Electronics Forum | Mon May 13 10:37:56 EDT 2002 | fmonette
The other important issue relates to moisture sensitive devices (MSD). If you have MSDs on the first side, you need to track the remaining floor life of the components on the partially assembled boards between the first and second reflow. Contrary to
Electronics Forum | Fri Apr 03 03:41:04 EST 1998 | Frank J. de Klein
150 secs. On bilayer boards (Cu only at top and bottom) you can typically not reach differences top to bottom bigger then 35-40 C. For multilayers however, the maximum is 15-20 C. If you actively cool a multi- layer at the bottom during the 2nd pass,
Electronics Forum | Fri May 24 19:18:03 EDT 2013 | hegemon
The formula is a great help, where was it 20 years ago? LOL After running a few thousand different products over the years, you start to get a feel for what is going to be trouble with regards to falling off the bottomside during the secondary refl
Electronics Forum | Thu Feb 11 09:59:49 EST 1999 | Dave f
| I would like to have information about the processability of different packages. | In particular I would like to known for which package I can use a double reflow for soldering. | | Best Regards | | | Michele: Double sided reflow is common pra
Electronics Forum | Wed May 15 12:55:11 EDT 2002 | fmonette
Hi Dave, The short answer is "not any significant amount" of moisture is removed during reflow. The temperature excursion is much too short. If you look at the physics of moisture diffusion inside a package you will see that only the surface moist
Electronics Forum | Tue Oct 05 02:47:01 EDT 1999 | Eric
| Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding so
Electronics Forum | Mon Oct 04 21:37:31 EDT 1999 | park kyung sam
| Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding so
Electronics Forum | Tue Oct 05 02:31:06 EDT 1999 | Eric
| | Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding
Electronics Forum | Tue May 14 21:07:03 EDT 2002 | ianchan
Hi mates, Yes, the lighter mass is a valid reasoning. in addition to the "lighter (mass) than thou" point of view, 1) the first reason for mounting active Parts (eg. IC, QFP, LGA...) is to minimize the temperature exposure of the Parts to a single
Electronics Forum | Thu Jul 20 16:56:39 EDT 2000 | lkoens1
Bob, Tell us more about this assembly concept