Full Site - : ecd super mole (Page 6 of 10)

thermocouple for profiling

Electronics Forum | Fri Apr 18 14:44:56 EDT 2008 | jax

Saunders Technology... or ECD (makers of M.O.L.E.) has what is called a TEMPROBE that will work how you want... even in "wet" solder paste. Maybe others here can tell you if it works well or not, I use KIC. www.ECD.com/saunders/tp.htm

MOLE's Oven rider

Electronics Forum | Mon Jan 04 22:59:23 EST 1999 | Kris Ewen

I'd like to add something about the ECD product. During a past work term (I'm a a co-op student) in an SMA plant, I worked extensively with the Super MOLE Gold in developing the reflow profiles for high-mix, low-volume production. I was 'married' t

Type K thermocouple for Super M.O.L.E

Electronics Forum | Sat Nov 03 05:19:59 EST 2001 | Ben

Hi I have question about thermocouple type use for Super M.O.L.E. I found in some article that type K T/C (Nickel-Chromium vs. Nickel-Aluminum) may suffer from temperature cycling hysteresis at above 250 degree C and also diffecult to solder. Now

Super M.O.L.E or Slim KIC 2000 for oven profiling?

Electronics Forum | Tue Jul 30 18:26:38 EDT 2002 | burb1999

MYDATA MY12 for the pick and place

Super Mole Gold Batter charger lost, please help!!!

Electronics Forum | Wed Sep 22 15:01:05 EDT 2004 | Hayden

Thank you for the help

Super M.O.L.E or Slim KIC 2000 for oven profiling?

Electronics Forum | Mon Jul 29 17:03:03 EDT 2002 | burb1999

Just setting up a new SMT line and have questions on which profiling product to use. So far the two in consideration are Super M.O.L.E. Gold and Slim KIC 2000... Please share any thoughts, experiences you have had with either and your opinion....

Thermal Profilers

Electronics Forum | Mon Jan 28 15:34:19 EST 2008 | slthomas

I have used the ECD MOLE and had no complaints. I also checked out a Datapaq at one time and really liked the software but it was a little on the spendy side. ECD provides free upgrades to their software which does provide some fairly helpful pred

Electrovert Omniflo 7 reflow ovens

Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu

180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and

Peak temperature of Reflow

Electronics Forum | Thu Aug 11 20:12:12 EDT 2016 | davef

Different points on the board couple have different thermal masses. Look here: http://www.ecd.com/portals/5/products/vmole/V-MOLE-Verify-3-Thermocouple.pdf

Thermal Profiler Batteries

Electronics Forum | Thu Mar 02 17:32:09 EST 2006 | sphilips

The initial cost of the battery is similar to saying the size of an iceberg is measured only by what shows above the waterline. There is a lot more to it than at first blush. The ECD Power Pack costs $245, but provides over 3500 hours of profiling.


ecd super mole searches for Companies, Equipment, Machines, Suppliers & Information