Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Thu Aug 04 03:56:38 EDT 2005 | Rob
Hi Danny, I do remember you recently suggested to a customer who was new to surface mount & wanted low volume the following equipment that you were selling: 1. MPM AP25 2. CP4 3. IP2 http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CF
Electronics Forum | Thu Jan 21 15:36:37 EST 2016 | brantco
I have the Error message E00900 i have checked the troubleshoot and it says to check SP1 XP6 and Y1 i have checked SP1 its ok, Relay XP6 seems ok Y1 i dont know where it is located here is the error "Air Pressure Fault" any help would be greatly
Electronics Forum | Wed Dec 02 06:57:18 EST 1998 | Brian Pollitt
We're using Cimetrix Host Manager to communicate with MPM UP3000 printers specifically to capture measurement and system settings and error messages. It all works fine until the printer is taken off line. The GEMComm S/W on the MPMs PC (DOS) doesn't
Electronics Forum | Thu Nov 11 18:36:29 EST 2004 | valuems
Hello We have been working on the MPM's for over 11 years now. And we have never had any trouble with that circuit, just goes to show you. If you have one of the old, old manuals you will find a lot of errors. They corrected them as they went. We
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Wed Apr 30 16:00:12 EDT 2008 | tech13108
Hello, We have recently purchased an older MPM via auction and I am trying to get it running but not getting too far. When I power it up it goes thru a boot sequence then a screen appears on the monitor with a "warning cover not closed, close cov
Electronics Forum | Sun Sep 25 20:20:22 EDT 2011 | johnyq
We recently aquired an old MPM-AP25 stencil printer that printed paste with a large error (about .060 inches). I concluded camera alignment to be the cause but was surprised by the magnitude. I found the camera beam splitter prism misaligned and loos