Electronics Forum | Thu Oct 25 16:48:29 EDT 2001 | Cemal Basaran
We can inspect and measure strain field in anything larger than 320nm with Laser techniques we have. We can do this measurements during fatigue testing. Of course thick intermetallic region as a solid region is a problem due to the fact that you ha
Electronics Forum | Wed Nov 20 18:41:57 EST 2002 | slthomas
Here's part of what I could read: "We evaluated the influence of Lift-off (Fillet-lifting) and the influence of thermal fatigue, in this case on combination between various terminal platings of electronic components and Pb-free solder, Sn-37Pb solde
Electronics Forum | Fri Aug 08 12:46:02 EDT 2003 | davef
When I was a salty old fart in the Navy, we sent the babes from the turnip patch off on snipe hunts. Shear tests are [in my opinion] senseless. The shear stress you measure depends more on the shear rate and on the point where the force is applied
Electronics Forum | Sat Sep 25 08:59:59 EDT 2004 | davef
IPC-HDBK-830, Guidelines for Design, Selection and Application of Conformal Coatings says: A conformal coating may have several functions depending on the type of application. The most common are: * Inhibit current leakage and short circuit due to h
Electronics Forum | Fri Jan 26 16:24:10 EST 2007 | Bob R.
Whether there's a fillet or not depends on the component type. Most have a fillet but some, such as QFN's, don't necessarily have one. Have a look at IPC-610D Workmanship Standards to understand when you should expect one and when you shouldn't. T
Electronics Forum | Mon Jan 07 09:25:55 EST 2008 | pjc
One per operator is the optimum for obvious. 3 to 4 per operator is more typical. The number is not as important as the type and time. Like don't have someone handle 2 different TO92 part nrs., splitting them up to different operators eliminates the
Electronics Forum | Wed Jun 30 12:41:25 EDT 2010 | rgduval
In general, if the process has been consistent for a period of time, then one should look at any new variables in the process. Therefore...the supposition that there's a bad lot of components is a very good one. Did Yageo offer any possible explana
Electronics Forum | Tue Nov 06 22:37:35 EST 2012 | davef
Ryan ... "As for bismuth-based lead-free alloys, a lower melting temperature than that of tin-lead is offered together with a cost similar to that of tin [in the area of $3/lb]. Unfortunately, bismuth in soldering alloys tends to create embrittlemen
Electronics Forum | Thu Mar 28 13:19:14 EDT 2019 | davef
There is no industry standard for BTC stand-off height. "IPC-7093A Design and Assembly Process Implementation for Bottom Termination SMT (BTC) Components" just finished "Final Draft for Industry Review" in December 2018. It mentions stand-off height
Electronics Forum | Fri Apr 10 20:27:07 EDT 1998 | Jean-Paul Clech
| I am currently involved in a reliability project related to SMT QFP and TSSOP fine pitch solder joint reliability. I have decided to use a temp chamber for stress testing. Is there a test standard that covers this? I am also a bit unsre as to wheth