Electronics Forum | Mon Oct 04 11:28:46 EDT 1999 | Mark D.
Does anyone have a list of component types that can be put on the bottomside of a doublesided reflow board that will not fall off during the second pass (Or on the otherhand, a list of components that will fall off)? This would be a list of parts tha
Electronics Forum | Mon Oct 04 11:23:55 EDT 1999 | Mark D.
Does anyone have a list of component types that can be put on the bottomside of a doublesided reflow board that will not fall off during the second pass (Or on the otherhand, a list of components that will fall off)? This would be a list of parts tha
Electronics Forum | Thu Jul 02 13:10:22 EDT 2009 | kpm135
On first glance it looks like those particular pads were not attached to any traces. If I had to guess I would say that your rework profile got hot enough to melt away the glue holding the pads to the board and they came away with your part when you
Electronics Forum | Thu Nov 01 04:32:52 EST 2001 | wbu
Jonathan, we do that all day. We do not use different pastes nor do we glue components nor do we run different profiles. Depends on what is meant by "small components". In our case it�s all that "bird seed" up to SO8. That will work for more parts.
Electronics Forum | Tue Dec 04 10:30:16 EST 2007 | slthomas
Q: The question I have is do they wet in wave solder, and if they do, why does it matter what happens to them in reflow? A: Yes, but somebody here don't agree with me that the glued part need help from wave to get the good wetting. They are wrong
Electronics Forum | Fri Jul 10 14:40:12 EDT 1998 | Bob Willis
Yes this can be a killer. Its caused by glues with a high water content or fast curing of glues. When you get solder going through the glue it is litterally sucked in during solder wave contact. If you have never seen it you would never believe it bu
Electronics Forum | Wed Oct 06 11:58:33 EDT 1999 | Wolfgang Busko
| | | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)
Electronics Forum | Thu Oct 07 06:02:38 EDT 1999 | Wolfgang Busko
| | | | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life
Electronics Forum | Thu Aug 17 01:31:31 EDT 2000 | Dreamsniper
Steve, I'm using 5 Sn/1.5 Ag/93.5 Pb Solder wire with a melting point of 300 deg. C to connect my thermocouples on smd components for thermal profiling. I'm using a soldering iron with an adjustable temp. to be able to melt my solder wire. Temp is ab
Electronics Forum | Tue Oct 05 03:49:04 EDT 1999 | Chris May
| Hi everyone, I need some help on the whole process of double sided surface mount. We have been doing surface mount for about 3 months and we're getting ready to take on our first doule sided board. I just need some step by step process regarding so