Electronics Forum | Tue Aug 27 17:54:19 EDT 2002 | carln
I finally found the answer! I just got back from visiting Smart Sonic out in LA. They have a new chemistry that works great (220-A SMD Adhesive Remover). I took two DEK plastic stencils with me and spread them both with Loctite 3616 and the system
Electronics Forum | Tue Sep 12 22:03:22 EDT 2006 | davef
Really Rocky? What's the meaning of Russ' "if it will fit" in your scheme? As an alternative to your scheme, he could glue the nut on its side, tie a string through the hole in the nut, attach the other end of the string to the open door, and the
Electronics Forum | Fri Aug 10 13:52:58 EDT 2001 | davef
When you say that glue viscosity changes for lot to lot, is this LOT TO LOT of your product OR Loctite�s product? And when you say that glue viscosity changes, what do you mean [eg, increase by � , decrease by � , er watt?]. What specifically is th
Electronics Forum | Sun Jul 25 08:54:37 EDT 1999 | Tom Gervascio
| We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that after
Electronics Forum | Thu Jun 04 12:26:30 EDT 1998 | Dave F
| If you could measure and chart 3 variables in my process, what would they be? | The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure
Electronics Forum | Mon Jul 26 10:25:12 EDT 1999 | Boca
| | We are having a process related problem with pullup resistors on a controller card which has a I960 micro-processor. | | The controller monitors signal inputs and it's own resources then blinks a LED to indicate its working. The problem is that a
Electronics Forum | Wed May 07 09:31:28 EDT 2003 | davef
We use uV Dymax glue for thermocouple attach sometimes, but don't like the remainder [anal] and loosing attach, sometimes. Roger Saunders, President Saunders Technology, Inc; said: PRO: � These products are easier to use than high temperature solde
Electronics Forum | Tue May 23 09:01:21 EDT 2000 | Wirat S.
Dear all friend, I found problem of soldering bridging between SMT Chip terminal & Glue , but under the chip body. My process was double side SMT assembly with bottom side adhesive & heat curing, then wave soldering with water soluble flux (OS type)
Electronics Forum | Tue Feb 27 03:35:23 EST 2001 | peterbarton
Steve, I have to support the comments made by Dave F. Provided the surface mount parts on the second side are correctly orientated and not too close to any adjacent through hole leads then the best option has to be to print glue then wave solder. T
Electronics Forum | Tue Jan 11 11:14:09 EST 2000 | Wolfgang Busko
What a challenge! I think it all depends on the equipment used. Seems rereflow of BGA isn�t that good (see the advices for wavesoldering BGA populated boards). Although you might check for the tacking force by sending a sample BGA board head over thr