Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
Electronics Forum | Thu Oct 24 23:19:55 EDT 2013 | wesleyintelli
Heads 2 & 3 on our CP45 are placing poorly. We believe that the head cameras are adjusting the component positions incorrectly since the placement is perfect when vision alignment is turned off. Does anyone have any experience with this issue or acce
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
Electronics Forum | Tue Oct 21 22:42:50 EDT 2008 | fujiphil
What error displayed after the vision process? If all the parts processed at Head 1 did not pass the vision, try to adjust the scan speed of the camera1. kindly send the error code. Jep
Electronics Forum | Sat Mar 26 02:38:07 EDT 2011 | evans1001
Had an issue with spindle 2 not coming down and picking parts up, then it was but not placing the part. The other 3 spindles were working fine. Changed the head on the machine but stil had the same issues. Anyone with any ideas. Cheers
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG
Make sure the program has been optimized to the current nozzle configuration.
Electronics Forum | Wed May 21 13:38:22 EDT 2008 | pjc
Solderpaste types have a big effect on print performance. Go to this link to see if the solderpaste you are using has been tested, see "Rheometric Pump Paste Tests" under MPM: http://www.speedlinetech.com/news_publications/application-notes.aspx?OnI
Electronics Forum | Tue Oct 21 06:33:18 EDT 2008 | maheshbs
Dear stany, sry for wrong reply.
