Electronics Forum | Thu Dec 03 15:41:09 EST 2015 | proceng1
We do run them through an Aqueous washer, but I don't see excessive deposits or anything before washing. And our wash is just heated DI water.
Electronics Forum | Wed Aug 01 01:35:22 EDT 2001 | DL
Jay, I agree with your assement and Chips on the Quads. I once worked at a shop that had Quads and DynaPerts(at the time) The perts were slower(TIME) and required(EFFORT/PEOPLE) more MAINTENANCE(more effort more people and more requirements!!!). I'v
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Sun Nov 08 17:04:26 EST 2015 | ttheis
Thank you very much for sharing this information. It is difficult to gain knowledge in this area independently. I'll contact Kester for information on adjusting the flux density and which "thinner" to use since I am using their flux. I really like
Electronics Forum | Thu Dec 03 14:37:53 EST 2015 | proceng1
Are you running a water or alcohol based flux? We run a water based product and it stays in the tank with the stone all week and is emptied and cleaned at the end of the production week. Never once have I stored the stone in thinner and I've never
Electronics Forum | Thu Dec 03 15:30:00 EST 2015 | ttheis
We've started off with Kester 951 'no-clean' so far which is alcohol based I believe. It seems to do very well with foaming, activation and low residue, but if we can move to water based and get good results that would be great. The 951 flux and thin
Electronics Forum | Thu Dec 03 15:34:57 EST 2015 | proceng1
Superior 420-XF-LF is what we use. When we switched, it took some time of just running it through the stone before we got the optimal performance. Especially when going into the clean and dry tank on monday morning, we usually let the fluxer run for
Electronics Forum | Sat Mar 11 08:53:44 EST 2017 | tch
My company is looking for a vacuum that can handle being used to clean up solder splashes on the bottom of our wave solder machines and around the solder pot area in our ERSA Selective Solder Machines. In the past we would use a Shopvac but these don
Electronics Forum | Mon Apr 01 05:05:40 EDT 2019 | robstevenson
I currently have Aegis CircuitCam Version 7.7.12.0 I have corrupted the mydata.mdb Does anyone know where I can get the original copy that came with software as I am not on maintenance contract any more. Also does anyone have a pdf copy of the Aegis
Electronics Forum | Wed May 20 14:03:53 EDT 2020 | dwl
Buy a dryer to go with your compressor. Compressed air traps a lot of water and you don't want that in your air lines on your P&P machines. Additionally, make sure you keep up with all the preventative maintenance and change out the filters as requir
