Electronics Forum | Sun May 28 19:02:11 EDT 2006 | grantp
Hi, One thing, getting back to the original topic, is you might want to panelize these boards as much as possible, as you don't have too many components, but you have some good volume. So the machine changeover time is going to be an issue. Althoug
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Wed Jan 02 07:12:14 EST 2002 | Cyber_Wolf
Well, Mydata did offer some suggestions.One of the suggestions was to go to all tape and reel.(We currently run about 25% of our parts in vibes.)Unfortunately we are in the contract buisness, and that is not an option. We run alot of odd sized parts
Electronics Forum | Fri Oct 25 10:22:34 EDT 2002 | dougt
Is anyone out there using bulk feeders? What component sizes are you running through them, anything other than 0201's? How about tube and vibe feeders, do these things have electronics on them now to keep track of part types, lane positions, etc.? I
Electronics Forum | Wed Oct 13 03:00:35 EDT 2004 | Grant
Hi, Ok that's a good idea, and they have a smaller tray feeder, so that's about the only problem I could see. I would love to get NXT, but it's just too expensive when compared to XP machines, but the dual lane is the extra I guess. I love the flexi
Electronics Forum | Mon Oct 17 15:11:34 EDT 2005 | ricardof
FUJI NXT single lane can run up to 23"x21". SIEMENS HF can run up to 23"x21" as well. Now, what kind of production are you doing? I think that 20" boards are for mid to low volume, my thinking is that SIEMENS can do that if you can afford the cost, o
Electronics Forum | Thu May 04 07:40:39 EDT 2006 | Chunks
Sounds like you're mad because they installed a "Yogic Only" express lane at your Wal Mart. I hate that too. I did replaced the filter in my Purex unit with a little somthing else, but if you worked here, you'd do it too. "You're Just Jealous Beca
Electronics Forum | Thu Dec 04 15:27:26 EST 2008 | jax
Check the spring tension on the reel holder. When the reels start running out of parts the spring can provide enough tension to keep the reel from spinning. I have seen this on some of the dual-lane feeders. Tape the spring back to verify. If this is
Electronics Forum | Mon Dec 08 07:52:22 EST 2008 | vleasher
Check the spring tension on the reel holder. When > the reels start running out of parts the spring > can provide enough tension to keep the reel from > spinning. I have seen this on some of the > dual-lane feeders. Tape the spring back to > ver
Electronics Forum | Wed Dec 26 08:24:13 EST 2012 | emeto
If you want to put them in a single lane to feed you pick and place, there might be some software challeges like first printer skip first board and print second....(for this you will have to contact your printer manufacturer,they will probably do it