Industry News | 2016-05-05 20:40:16.0
Scienscope International has appointed Ark Manufacturing Solutions as its exclusive manufacturers’ representative in the Southwestern U.S. ARK Manufacturing Solutions will represent Scienscope’s state-of-the-art X-ray cabinet systems.
Industry News | 2018-01-16 11:59:10.0
Vision Engineering has teamed up with industry-expert Bob Willis to broadcast a free Electronics Academy Webinar aimed at identifying the issues affecting PCB/SMT assembly and the challenges of achieving Zero Defect Manufacture. The next webinar, Eliminate Printed Circuit Board Problems & Failure Modes will take place on January 23rd at 2:30 EST.
Industry News | 2019-01-22 12:13:14.0
Practical Tools announces that it will welcome RBP Chemical Technology to their booth 2499 at the 2019 MD&M exhibition to take place February 5-7, 2019 at the Anaheim Convention Center, in Anaheim, CA.
Industry News | 2021-12-17 16:28:07.0
See equipment and talk to experts about the latest in fluid dispensing, test, inspection, and plasma treatment in one booth, #I2716
Industry News | 2017-06-01 19:11:01.0
Ascentech will exhibit and demonstrate advanced Optilia, Inspectis, and GEN3 test and process optimization instruments and solutions at the upcoming SMTA Empire Expo & Tech Forum, Thursday, June 15, 2017 at the Holiday Inn Syracuse/Liverpool, 441 Electronics Parkway, Liverpool, New York.
Industry News | 2017-07-06 09:50:09.0
Ascentech will exhibit and demonstrate advanced Optilia, Inspectis, and GEN3 test and process optimization instruments and solutions at the upcoming SMTA Ohio Expo & Tech Forum, July 13, 2017, at the Embassy Suites Cleveland Rockside in Independence (Cleveland), Ohio.
Electronics Forum | Fri Sep 12 09:10:23 EDT 2003 | Norm Morikawa
Around 1989 I had this probelmm with a SMT CCA that would not solder in one area consistently. I had it cross sectioned by the bare board supplier and found that under their metallurgical microscope the thickness of this HASL bare board could not be
Electronics Forum | Wed Nov 06 05:13:01 EST 2002 | Dreamsniper
Crystalline flux if it is really clear should not be a problem. We were using Amtech paste before and we have the same results. Sometimes we mistakenly see it as a dry joint because of the reflections from the lighting of our Metcal inspection system
Electronics Forum | Wed May 25 17:58:07 EDT 2011 | rssimmons
The SimmScope is a first article inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator to
Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,