Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan
Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P
Electronics Forum | Tue Sep 16 09:26:26 EDT 2008 | mi
Hello, I have programmed SMT placement for Mydata My9 machines. I have ported programs between Mydata-to-Mydata machines. Also from Mydata to AOI machine for SMT inspection. Is there a way to port a placement program from Mydata to Panasonic MSH2
Electronics Forum | Wed Oct 19 17:39:51 EDT 2022 | rgduval
The Agilis feeders are much more reliable than the old TM feeders. You can tweak the TMs a little bit, but, it can be a pain. Agilis have better repeatability, and built in y axis correction for 0402 and smaller parts. On the newer machines (My se
Electronics Forum | Tue Oct 25 09:20:10 EDT 2005 | meritajs
Hi, We have problem with y-axis offset at YM84 After setting the ORIGIN machine operate exactly but after sometime y-axis recieves offset bis 5-10mm.After repeated setting ORIGIN Y-coordinat became exact. The same things take place if we operate in W
Electronics Forum | Mon Nov 17 00:13:46 EST 2003 | shawn
if george idea doesn't solve ur problem then it must either be the driver or the y-axis motor itself.try swaping the driver with other machines if u can afford it . good luck.keep me posted of the developments.
Electronics Forum | Thu Jul 27 22:27:45 EDT 2006 | seth
Vision X-Y maintenance procedure, please advise. I have problem with camera not park so often time, and I don't have any solution accept buying a new vision Y right stepper motor, but that's just too much money roughly 2500 dollars.
Electronics Forum | Wed Jul 03 07:49:35 EDT 2019 | daniel_marquette
Got it. Servo tuning is new to us, so we'll try it. When you propose to swap the Y axis amps, do you refer to the driver that controls the Y motors? Thanks,
Electronics Forum | Wed Oct 02 00:35:33 EDT 2013 | sonavc
thanks I tested the conveyor A or B , when it is on the motor turn and the green LED at the out put card is also light on. But when i turn on the X y table motor , the green LED is on , but the motor is not run. I will try to replace the I/O
Electronics Forum | Thu Aug 02 09:14:17 EDT 2018 | jeffallen662
Hey I'm having some issues with a YesTech YTV-1000 AOI machine. The machine isn't recognizing the X and the Y stepper motors. As far as we can tell nothing mechanical is wrong with the AOI. They are new motors and were suppose to have been programmed
Electronics Forum | Thu Mar 10 23:23:56 EST 2005 | pmd
We have a MyData TP-9-2 with a in line Y wagon. It is a long screw and the vintage is 1994. The Y wagon vibrates at about 24 micrometers at about 25 hertz. Burnin reviels zero encoder pulse errors. Hystersis test indicates a Y axis Y wise varance of
winsouce.jpg)
