Electronics Forum | Wed Sep 27 19:57:41 EDT 2000 | Dave F
Our display suppliers provide displays either with: * Molded plastic cover that we recycle to them * Plastic film like the guys that change your oil put on your wind shield to remind you when to get your oil changed.
Electronics Forum | Mon Oct 14 03:03:34 EDT 2002 | msimkin
Mike, I have been using a fully synthetic motor oil on the links of my chains of my Hella for 7 years now, and have had no problems. As long as you do not place the oil on the fingers, where it makes contact with the PCB, then you will have no probl
Electronics Forum | Tue Feb 15 08:33:52 EST 2005 | jdengler
I had a similar problem on another machine. It turned out to be the wrong oil used on the nozzle shaft. This oil was a higher viscosity, which caused the nozzles to stick at start-up. After the machine ran for a few minutes everything returned to
Electronics Forum | Mon Sep 04 10:53:22 EDT 2006 | Thomas
Dear Sir, We produce solder dross reducing Powder and wave oil in India.The powder that really helps (80%) to reclaim good solder from dross and the oil will act as a blanket on top of the molten solder.contact for details metalconnect@vsnl.net with
Electronics Forum | Wed Aug 09 12:18:06 EDT 2006 | PR
We had to replace the chains on our Omni as well. We used a non-approved oil which build up so much carbon the links would not move. Since using the high temp oil they recommend, no problems.
Electronics Forum | Wed Aug 27 14:02:46 EDT 2008 | jeffharley
We use a power washer, blow dry, then lightly oil the links with mineral oil. Works great
Electronics Forum | Tue Aug 11 16:18:41 EDT 2009 | dyoungquist
Oberon (oberonlube.com) makes a high temperature chain lube (oil). When our Heller oven was installed, we were told to use this as the replacement when our original volume of chain oil ran out. I do not know the price for it.
Electronics Forum | Sat Oct 17 22:04:39 EDT 2009 | isd_jwendell
Oil will make them act faster/smoother, but will collect dirt and dust faster. I prefer to oil, and clean more often.
Electronics Forum | Sun Oct 18 17:34:40 EDT 2009 | emanuel
The main question is, where is the problem: With the piston, in which case I can use some air oil on the rod or even a small drop in the air tube. OR With the mechanics, specifically the sprocket in which case I am not sure oiling only without prior
Electronics Forum | Thu Apr 29 15:34:40 EDT 2010 | bradlanger
Does anybody know where you can get Canada Bolson Oil or Suitable alternative that is optically clear to test the plating in a PTH for outgassing?
