Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Fri Feb 15 15:55:58 EST 2008 | pjc
This is from the OmniFlo 5 Engineering data sheet: EXHAUST SPECIFICATIONS: STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 300 cfm (510 m3/hr) at the 4� (102 mm) stack (minimum req
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Electronics Forum | Tue Feb 17 12:58:11 EST 2015 | anvil1021
The MV-7 OMNI is a Great Machine, has the same 3D Solution MV-9 Quad Moire Multi Frequency System. You will not be disappointed, you will find new ways to use the 3D system as time goes on and it is rock stable and incredibly precise. Either the MV-
Electronics Forum | Thu Oct 11 16:23:28 EDT 2018 | bdamico
Hello Doug, Thank you for the reference on our vintage MV-3L systems. It is always a pleasure to receive positive feedback from our valued customers. I also saw that you were in the market for 3D AOI. Are you familair with our MV-3 OMNI Desktop 3
Electronics Forum | Fri Jan 21 15:33:43 EST 2005 | Mark
>Hours mean nothing on these machines. Correct me if I am wrong but isn't it true that heaters and blowers (maybe valves) have a specific lifespan? I would think that parts in an oven with many hours on it are due to fail sooner than those in one wit
Electronics Forum | Sat Feb 05 15:07:50 EST 2005 | etienne
??? Your reply was of no interest to anyone.....If the person above wanted to share his name and surname, he would probabbly have written them down, so please let us keep everybody's privacy, and thank people like Marc C who give us answers when we a
Electronics Forum | Thu Aug 11 16:20:54 EDT 2005 | pjc
I have seen good results on OmniFlo 5 for Pb Free solderpastes PROVIDED the boards are low to medium thermal mass and have no high conveyor speed (high production) requirements. Max peak temp you can set on O5 is 280C, enough to get 230C on-board tem
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Tue Sep 11 08:36:53 EDT 2007 | cyber_wolf
We seem to have a lot of blowers going bad on our Omni 10 lately. We run PB free and/or elevated sn/pb profiles on a regular basis. I am starting to suspect that the elevated zone temps are causing the blowers to fail. Has anyone else had this prob