Electronics Forum | Wed Nov 30 20:43:06 EST 2016 | ttheis
OK, so went to power up again today and had the same kind of issues. The 24V and 5V lights on the cage flicker dimly about every 500ms. I tried my trick of disconnecting the +24v lead to the lift table amp and it acted the same, so it didn't work th
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Fri Feb 18 21:34:36 EST 2000 | gwen
We always have big power modules on the board,they are very heavy,so we use the screw to fix the soldered module,then we destroyed the solder joints.If we screw them first, the board can't be wave soldered. My questions: whether we should use the s
Electronics Forum | Fri Feb 18 21:34:36 EST 2000 | gwen
We always have big power modules on the board,they are very heavy,so we use the screw to fix the soldered module,then we destroyed the solder joints.If we screw them first, the board can't be wave soldered. My questions: whether we should use the s
Electronics Forum | Tue Apr 30 10:03:31 EDT 2013 | mmjm_1099
Got it powered back on Friday.... We did check the UPS (power-supply)and indeed it was bad. So we referenced the manual and found you can bypass the UPS all together. So we just directly plugged the machine past the UPS. Well the machine is running b
Electronics Forum | Thu Feb 19 12:22:52 EST 2015 | dman97
Hi there. I have an IP3 machine that refuses to power up the MFU cart on side 1. I have already replaced the I/O card but still no dice. Is there a relay or fuse that I need to check to get this to power up? The machine will not operate the camera
Electronics Forum | Sun Nov 27 16:53:39 EST 2016 | ttheis
Our UP500 has been running great for a few months then the AC/DC 5/12/24V power supply stopped working and the PC could not communicate with the cage. The PC screen also got very noisy. We replaced the power supply with a used replacement and the ma
Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
Electronics Forum | Thu Dec 08 09:54:53 EST 2011 | dyoungquist
Since it is listed as "Typical Run Current", my assumption is that is the current after it has heated up and stabilized at your profile settings, i.e. not start up. The recommended breaker size is 100 Amps. That would imply it can draw more than th