Electronics Forum | Wed Feb 08 16:01:56 EST 2012 | gosswald
Are you using Auto Program to generate the board program? If your camera offset and mod codes are OK I would check your board position settings in Auto Program and make sure they are correct. For me at least, board globals, position, and fidicuals
Electronics Forum | Wed Jul 06 08:02:54 EDT 2011 | jholif
bought the cable replacement kit and replaced all of the ribbon cables and still the deadly motor error 4. Everything in the system has been replaced except the X motor and the Y motor cable.
Electronics Forum | Tue Nov 08 15:07:51 EST 2011 | gosswald
I have been in the process of setting up a Quad 2C that lost its mod codes myself. Have you cleaned the glass encoder strips for X and Y? I was getting alot of motor errors until I cleaned them and I believe it was the error 4. Hope this helps.
Electronics Forum | Wed Jul 06 09:10:55 EDT 2011 | bobpan
i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them Bob
Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
Electronics Forum | Sat Jun 27 15:37:15 EDT 2020 | spoiltforchoice
rx8pilot has one of those - long thread here https://www.eevblog.com/forum/reviews/finally-have-a-pick-and-place-on-the-way-quad-ivc/ Clearly the platform itself is very well made although some of the weird debugging codes and errors posted on this
Electronics Forum | Fri Aug 02 12:03:16 EDT 2019 | dfl
UPDATE: I was reading around about similar problems. My function #30 always return nozzle height 1. I tried to clean up the glasses and the internal laser lenses, no go, still at height 1. Even after removing both glasses, still at height 1. I saw s
Electronics Forum | Sun Aug 04 08:47:12 EDT 2019 | dfl
Hey bob, I had no luck. Even removing both glasses, cleaning that curved lenses with a cotton swab and isopropanol and blowing compressed air, the height still on 1. I will try on the next weekend again, to be sure, but my first guess is the QA un
Electronics Forum | Thu Apr 17 11:59:59 EDT 2014 | briantmc
Hi all. A "newbie" on the forum, hopefully someone can help! I have a Quad IVc that has developed a problem on its Theta Axis. In performing the Homing routine it does not spin the nozzle through 360 deg as it should. It does a small turn ~45deg o
Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette
Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and
