Electronics Forum | Thu Jun 01 07:40:23 EDT 2006 | netellink
I have a Suzuki vision machine with 4 heads (SMT-1000VL). This machine is using the camera to inspect the nozzels (4 sets) in the nozzel tray changer every time it is going to change the nozzel(s) in the 4 heads. The problem I have is now the machine
Electronics Forum | Mon Feb 12 09:44:47 EST 2007 | SWAG
Enhanced board set-up, set conveyor width, load board, (your fiducials must be accurate!), use two fiducials to set reference point, click on placement(s), move crosshair to centerpoint, use two point teach to teach one point in the center or use cor
Electronics Forum | Wed May 21 00:28:42 EDT 2008 | grayman
Hello, My Friend from USA wants to set up new factory for SMT production (expansion line). Currently, he has production lines in the USA (10 lines with testing). Initially, he will set up 3 lines to produce power supply like AVR and UPS. He doesn't
Electronics Forum | Wed Aug 13 09:11:19 EDT 2008 | rgduval
Shane, We're assuming that the software is similar to our Heller 1800. We're also assuming that the oven has thermocouple ports, and that you have the thermocouples to plug into them. From the screen that displays the zone data, there should be a
Electronics Forum | Thu Sep 04 09:05:00 EDT 2014 | JB
Hello All. Another question about programming if anyone could help? We are current placing BGA's and it places them fine but we have noticed it doesn't spot when a ball is missing. We have adjusted the settings so it does reliably spot the missing
Electronics Forum | Sun Apr 07 00:45:21 EDT 2019 | d_nguyen2018
Hi, Can you show me how to set up tray table? I have 1 x 10 pockets tape with 10 PQFPs. I went into Magazines then selected Tray Wagon. I did first and last part on the 1 x 10 tape pockets but it did not work. I was told that I must set up the tray
Electronics Forum | Mon Jul 15 09:42:49 EDT 2019 | mleclair
I purchased some RS232 breakout board connectors so I'm making the cables now based on the pinout document page 4 (DB9 to DB25) but i'm still getting the message below: "unable to transmit to machine 61700025 Unable to log on to the Machine Communic
Electronics Forum | Tue Jun 20 17:56:39 EDT 2000 | Gary Kemp
Can anyone give me a ballpark figure on where to set the temperature for the pre-heaters of a wave solder? Any responses are greatly appreciated.
Electronics Forum | Sat Jan 22 15:11:50 EST 2000 | Ace
We had a set custom made for a fraction of the cost Camalot wants for them. Just take some measurements form your current set. It won't be too difficult.
Electronics Forum | Mon Dec 20 17:02:39 EST 1999 | Dave F
Charlie: There's a lot of background setting-up fluxers (including sprayers) in the archives. Chris Shea wrote a paper that's in the library (or where ever SMTnet stores stuff like that) that is pretty good. Good luck. Dave F