Electronics Forum | Mon Jun 05 15:33:41 EDT 2017 | deanm
Rick, You might want to consider a Quad 4000C. Even though Quad is out of business, parts and support are available from Precision Placement Machines. They are rebuilt with a warranty and run Windows 7. They offer intelligent feeders and if you don'
Electronics Forum | Tue May 23 02:33:38 EDT 2017 | tsvetan
When you buy pick and place machine there are few things to consider: 1. Always buy fastest and greatest machine which you can afford, faster machines has lower cost per placed components and you have room for your business to grow. 2. Always buy m
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Electronics Forum | Thu Dec 08 22:57:45 EST 2016 | ttheis
I'm not too experienced with this but what about an air-blast with an ionized air source such as an air knife above and below a conveyor to push most of the fluid off of the pcba then run through an oven just above vaporization temperature.
Electronics Forum | Mon Jul 07 21:14:35 EDT 2014 | andrespena
Thanks for the info because I honestly have no darn clue about the whole industry. Does anyone know why it is expensive to have an operator? If it has conveyors can't it operate on its own? Why are the boards expensive? Why wouldn't any rigid piece
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently
Electronics Forum | Thu Nov 17 20:51:16 EST 2005 | cangly
Morning Mike, We use Pb63/Sn37, Alpha Metal alloy. Solder pot is at 250 C. The profile of board after Preheat about 100 C, Lambda Wave about 220C (use both Lambda and Chip wave), DWell time 2.1s ~ 3s. Conveyor speed 1.5 in/min. We run by bare board a
Electronics Forum | Wed Jan 17 07:58:31 EST 2018 | lokiz
Greetings, I have been told that auto rail width with the Samsung SM320 is a purchased option opposed to a standard feature. What I would like to know is what all comes in the auto rail width kit. It looks to me like the wire harness where the rai
Electronics Forum | Tue Oct 27 15:25:02 EST 1998 | Stefan W.
Hi Samson ! In order to give you more detailed information I would like to know what your component range is and how many boards you supposed to do. Panasonic and MPM are a good choice, however, Panasonic has not many P&P machines on the U.S. market,
