Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Wed Aug 05 14:18:47 EDT 2020 | dwl
Anything with metal in it can be recycled; PCBs, wire, lead trimmings, used solder paste, etc. There are companies that specialize in this sort of waste. Typically they will provide you with containers and once you have enough waste, they will come p
Electronics Forum | Tue Sep 15 21:05:37 EDT 2020 | bmalhi
Please try to run wakeup recipe and heat up one zone at a time to see if its related to any zone or load on the facility side. Please contact Heller ServiceNJ@hellerindustries.com to get help with the issue.
Electronics Forum | Tue Oct 06 16:35:11 EDT 2020 | stephendo
I was about to suggest going to a smaller inductor and using traces to make up the difference. But I don't think that will work with mH.
Electronics Forum | Thu Oct 01 17:15:50 EDT 2020 | spoiltforchoice
Stress concerns, spread over 50 pins. Madness, but then people do still seem to have a level of paranoia with SMT. Here we'd suck it up and handsolder them, and the operatives would not be happy about it.
Electronics Forum | Fri Dec 04 13:17:14 EST 2020 | cyber_wolf
As a side note, you get to clean up all the paste that pukes on the bottom heaters of your reflow oven.
Electronics Forum | Fri Oct 23 18:33:16 EDT 2020 | emeto
Hello, I had them 10yesrs ago. Solid, sturdy machine with 30 heads. Software was not my favourite, but once you set them up, they never stop.
Electronics Forum | Mon Nov 09 15:44:39 EST 2020 | mikewschomisch
DEK 265LT displays CMOC is BAD: Restoring from EEPROM.... EEPROM is BAD: No Restore was made. You MUST run SETUP followed by LOCKMOS... FAILED Any help appreciated.
Electronics Forum | Tue Nov 10 19:20:34 EST 2020 | dekhead
Can you manually enter CMOS information in Setup and boot from there?
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
