Electronics Forum | Tue Aug 19 17:55:28 EDT 2003 | adlsmt
Anyone have a good source for respirators, gloves, aprons etc. for working on wave solder machines? Is there some industry standard for what is required?
Electronics Forum | Wed Jul 01 16:21:41 EDT 2020 | emeto
It is usually done differently. Sensor is in the solder. Once solder becomes goes below the sensor, it triggers you need to add. I believe it measures temperature rather than distance.
Electronics Forum | Thu Dec 01 05:23:55 EST 2016 | stivais
Rob Just wondering - have you made analysis of your solder alloy on a regular basis? We are using SAC305 but stainless steel parts (e.g. a nut or a washer) dissolve quite quickly.
Electronics Forum | Thu Dec 01 07:41:33 EST 2016 | robl
Hi Stivais, Yes, we analyse once a week in 4 pot locations, in addition one of our customers also takes an audit sample once a month and XRF's it. So far no spikes in the stainless pot that are not found in the titanium pot. Thanks, Rob.
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Fri Jun 12 11:15:50 EDT 1998 | Ryan Jennens
Hey all! The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pallet w
Electronics Forum | Sun Sep 10 18:54:12 EDT 2000 | Craig
Does anybody do this? Are there any problems with doing this? Thanks Craig
Electronics Forum | Sun Nov 27 05:04:02 EST 2016 | pmcg
Never used stainless pots as when we converted to lead free we changed all the pots to titanium. Been using SN100C for many years now, very good results, also use it in reel form in our selective solder machines with great results. Bear in mind the
Electronics Forum | Fri Jun 26 00:33:08 EDT 2020 | victorzubashev
Hello everyone, Can you please recommend a sensor to measure (contactless) level of solder inside of the wave soldering bath? ideally it should be a sensor that can reliably measure distanceto the melted solder and provide distance (as a codified si
Electronics Forum | Thu Dec 01 04:32:28 EST 2016 | Rob
We've run for about 2 years with SN100C on a Stainless pot, and all looking OK at the moment - we have just drained the pot and swapped to a similar solder (customer request)so we had a good look as we were interested to see what was happening. To be
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774