Electronics Forum | Tue Jul 18 16:49:49 EDT 2023 | mahasg
Hello All, I am PhD student at polytechnique Montreal. We have a CQFP44 packages and Dies of 51um pad pitch (22nm FDSOI tech) that I need to bond myself at the university using ASM Eagle Xtreme gold wire bonder in the university. we need to perform b
Electronics Forum | Tue Aug 21 22:24:36 EDT 2001 | davef
Root around here http://www.kns.com/resources/library/lib-wirebonding.asp
Electronics Forum | Thu Jan 29 05:13:35 EST 2015 | neeraj_iiser
how to solder manganin 0.05mm manganin wire to a copper plate
Electronics Forum | Fri Jan 30 00:41:04 EST 2015 | neeraj_iiser
Thanks a lot , my application is cryogenic in nature. I am trying to make a Sub-Angstrom resolution Thermal expansion sensor, whose components have been machined out of OHFC copper, and i needed to solder a manganin wire to one of the capcitor plates
Electronics Forum | Thu Jun 08 11:37:44 EDT 2017 | jkitt84
davef, thanks for feedback. I talked with a plater who said they put copper before silver when plating brass. Would a complete stack of: Brass part, then 0.0001-0.0002" of copper, then 0.0005" of silver, then Tarniban anti oxidation. Sound reasonabl
Electronics Forum | Tue Apr 16 05:05:32 EDT 2013 | stivais
We recently had a discussion with customer's QM - he claims that calculations for a proper solder wire diameter and soldering iron tip size (and temperature) have to be performed and documented for all manual (T/H) solderings (based on component size
Electronics Forum | Thu Jan 29 09:18:36 EST 2015 | davef
Nichrome, manganin, phosphor bronze etc are easy to solder ... the hard part is removing the corrosion * Manganin: 86% copper, 12% manganese, 2% nickel. Often, it's used in making cryogenic measurements, due to its low heat loss. * Select a flux for
Electronics Forum | Fri Dec 03 18:17:12 EST 1999 | Dave F
Dave: There's lots of stuff on the web describing BGAs. Examples are: http://www.smtnet.com/bookstore/publications/0speckdo1/s1.html http://www.smtnet.com/bookstore/publications/0shutcco1/ch1p2.html http://www.citizen-america.com/OEM/bga/process
Electronics Forum | Wed May 18 07:22:06 EDT 2005 | davef
Wire bonds don't stick when bonded * Check pull and shear strength. * Depending on point of failure, review parameters. * Listen during bonding, if there is a high pitch buzz, there is vibration in the system somewhere, "seek and destroy". * Get the
Electronics Forum | Fri Dec 16 13:37:52 EST 2016 | edhare
Hi all, > > Recently, we are trying to do > wire bonding between a 75 * 75 um pad on a chip > and substrate with 150 um height difference, but > when completing wire bonding and the wire bonds > on pad and substrate, the pad will get out of