Electronics Forum | Tue Aug 22 10:22:59 EDT 2000 | Wolfgang Busko
Mark: The fact that these daughter boards have to be attached to the TSOP-footprints is what makes the thing difficult cause they will be greater than the original part. One could think that a LCC-design allows for proper routing. But when it comes t
Electronics Forum | Wed Jun 25 10:29:32 EDT 2003 | caldon
Hey Mike- We ran into the same thing when we purchased a Large CanadianManufacturers repair business. We were creative and first used an ESD bag cut open (Simulate the paper idea) then we used a 3M parts bin and would tip it on its corner to funnel t
Electronics Forum | Mon Jul 30 16:14:49 EDT 2007 | davef
Sure, 99 percent of the planet uses 3M double-sided tape #666 tape in helping to verify first piece after a new placement program, but is that the best there is out there? We have this 3X5 card sized "Sample - Double Stick Sheets," which [according
Electronics Forum | Tue Jun 22 13:56:55 EDT 1999 | Deon Nungaray
| I was wondering if anybody could give an estimated cost of equipment maintenance per year for a complete SMT line for | a medium volume facility? | Deon Rresponse: Hi John, Your question is very generalized. I think that in order to make a good
Electronics Forum | Wed Sep 18 14:58:59 EDT 2002 | Claude_Couture
Just to add my 2 cents on the adjustment of pitch on MPA feeders: True: Panasonic do not make it easy to change the pitch on MPA feeders, the thickness of a metal part is what sets the pitch. My solution: for example, I get a 24mm X 12mm pitch MPA
Electronics Forum | Fri Nov 01 09:35:52 EST 2002 | James Bartlett
MINIMUM NDSU EMEG EQUIPMENT SPECIFICATIONS (11/1/02) To serve microsensor research and development via the Center for Nano-scale Science and Engineering (CNSE), the North Dakota State University (NDSU) Electronics Manufacturing Engineering Group (EM
Electronics Forum | Wed Apr 21 18:24:13 EDT 2004 | pjohnson@volterra.com
Simple process - we use similar Kester solder brands of "no clean" low residue solder wick to clean our pads, then brush with isopropyl, and apply Kesters brand of tacky flux under a Leica 6x microscope. We do this on 7x7mm and 9x9mm packages. This w
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Tue Apr 02 07:12:38 EDT 2019 | jchris
I worked with a PACE TF1800 for about a month on a project last year and it performed flawlessly for BGA and QFN installations and removals. It can handle boards up to 12"x12". Really easy to use with excellent profiling software that walks you throu
Electronics Forum | Tue Dec 03 18:51:57 EST 2019 | kylehunter
Hi all, We are having a confusing defect with one of our client's boards. It is a large board, 30" x 12". The client supplies the LEDs, they are cheap overseas diodes, and it is not uncommon to have reels with the packaging torn. We have w