Electronics Forum | Tue May 04 11:30:19 EDT 2010 | tsventek
I just had the same issue, it was a corrupt fiducial file in the program that kept on loading when booted. If your vision card is working follow these steps: Reboot the machine, press F5 when the computer beeps to enter DOS, delete the file maninf.d
Electronics Forum | Wed May 19 14:38:59 EDT 2010 | davef
It's a serious problem. Here's a link to an earlier thread on SMTnet: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=60545 For more try: * escsinfo.com * AS9120 * AS5553.info * combatcounterfeits.com * safesourcesseal.com Recent trade
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Wed Feb 16 01:06:13 EST 2011 | vinitverma
Dear Gabe, Once you have the mount data in the program, you can move the camera automatically to the location by tracing each location one by one. If I remember it correctly it is done by having the location highlighted in the program and then by pr
Electronics Forum | Mon Mar 05 13:35:04 EST 2012 | acsscott
Figured out that you have to press Ctrl & Enter to get this screen to come up. Also, to remove the LCS, you need to remove the "Y" cable to the left of the control box in the bottom of the Topaz X. All works well now, but still can't get it to load
Electronics Forum | Thu Mar 29 07:37:45 EDT 2012 | davef
The current discussion about solder fountains has to do with copper dissolution. Broadly, copper dissolution is the weakening of copper traces where a trace and a barrel plating intersect due a loss of the copper into the solder. Longer contact time
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Jun 28 15:22:59 EDT 2012 | spitkis2
Would like to ask end users or those with experience using infra red rework equipment (specifically when the top heater is IR) the following: 1. Can you successfully rework Package On Package (PoP) type devices? With heat directed through the packa
Electronics Forum | Sun Mar 24 17:28:20 EDT 2013 | vikkaraja
Thanks for all the help you are giving me but I just can't put my finger on this annoying problem. I checked and recheck all sensors without much sucess against the I/O. Something I am not understand is these two followning conditions--- first one I
Electronics Forum | Wed Apr 10 15:05:23 EDT 2013 | microaide
I followed your instructions and did NOT select the option to break up the program for separate central controllers. I now have a program I can copy to central controller #1, and I can delete the head 2 data from the program. Now when I select RUN TH
