Electronics Forum | Fri Jun 12 18:21:52 EDT 2020 | proceng1
I've had components move in the pocket and cause mis-picks. Generally, the part moves, but settles in the pocket after a moment. So I slowed down the pick up speed. It gave the part in the feeder a chance to settle before picking.
Electronics Forum | Tue Jul 21 14:22:58 EDT 2020 | emeto
As part of the evolution, electronic feeder has a lot of advantages - precision, programming and speed. If you build low volume easy boards you can probably stick with the mechanical feeders. For challenge and volume, I would suggest you move on to t
Electronics Forum | Thu Jul 23 13:44:50 EDT 2020 | dwl
I used to have the same issue with reed switches on one product we ran. Same oven too. We ended up rigging up an "umbrella" with two titanium stiffeners and bare PCB as the roof. It was hokey but it worked.
Electronics Forum | Mon Jul 27 20:26:44 EDT 2020 | kghadiya
Good idea DWL, "Umbrella" thing works to solve this problem temporarily. But do you think it will cause any damage to hitter or heat zone?
Electronics Forum | Thu Feb 04 15:57:13 EST 2021 | dilogic
We had the same problem and it was caused by faulty encoder, which we had to replace. - Dejan
Electronics Forum | Tue Apr 06 09:20:04 EDT 2021 | vasu278
Hi Anyone using reflow which is similar to Jaguar M8. I need electrical manual iam getting some issues like speed is not setting below 58cm/min and can't find smema connection also
Electronics Forum | Thu Sep 23 07:52:20 EDT 2021 | kojotssss
We use WRN (wide range nozzle) depend of head you use. H08, H02... Before pickup just make pickup offset and reduce pick up, transport speed. But, standard nozzle also could be used.
Electronics Forum | Tue Oct 26 12:11:51 EDT 2021 | dontfeedphils
Here's a link to this section in the manual. https://drive.google.com/file/d/1NyhITSDlkP2ZrQoxBtoFhHDmn3p89O4W/view?usp=sharing
Electronics Forum | Mon Apr 25 17:15:45 EDT 2022 | SMTA-64387687
It's difficult to diagnose without the LED specs. Is the spacing between the pads the same? Your pads seem too large for the Nichia part. Try reducing the stencil apertures to deposit less paste and closer to the inside edge. Depending on your oven,
Electronics Forum | Tue Jul 26 13:04:02 EDT 2022 | kumarb
Hi. Sharing a new contact we have from a company in Shenzhen that has a focus on refurb machines that may be worth a quick call: www.qy-smt.com smtripathy[at]qy-smt.com They apparently setup up shops even on a rental basis! Unbelievable that they w
.gif)
