Electronics Forum | Wed Apr 08 00:31:31 EDT 1998 | Mike Moninger
| I have a need to have a number (approx 20) circuit | card assemblies which need to have a silicone conformal | coating applied per MIL-I-46058. Are there any facilities | which can offer me this service? | Thank you, | Chris Fontaine | (603)885-
Electronics Forum | Fri Apr 24 15:28:06 EDT 1998 | joe devaney
| I am looking for suppliers of SMT setup verification | systems that use bar code lables as the medium. | I have located Brady and Unicam's verifeed. We have | immediate need due to the push to remove component | markings. We have two lines presentl
Electronics Forum | Fri Apr 17 19:40:16 EDT 1998 | M. Faisal Pandit
| I am looking for suppliers of SMT setup verification | systems that use bar code lables as the medium. | I have located Brady and Unicam's verifeed. We have | immediate need due to the push to remove component | markings. We have two lines presentl
Electronics Forum | Wed Apr 08 16:02:38 EDT 1998 | Mike Newkirk
Hello Reza! The best place to start is to come visit our demo lab in Raleigh North Carolina and we will give you an in depth review of SMT assembly Best regards, Mike Newkirk Vice President, Sales and Customer Support | Hi, | I have been assigned to
Electronics Forum | Mon Apr 20 18:59:24 EDT 1998 | Earl Moon
| Hello Reza! | The best place to start is to come visit our demo lab | in Raleigh North Carolina and we will give you an | in depth review of SMT assembly | Best regards, | Mike Newkirk | Vice President, Sales and Customer Support Mike, You don't w
Electronics Forum | Mon Apr 06 10:32:53 EDT 1998 | Justin Medernach
| Peter, | Take a look at IPC-ANSI J-STD-001A and B, J-STD-004 and I think, 005/006 which cover solder paste (?) I think. | Whatever, they do reference one another. | | Question: Whatparameters are used to determine "good" Solder Paste? What refer
Electronics Forum | Sun Apr 05 08:02:32 EDT 1998 | Helmut Pawelka
Dear Peter, out of the manufacturers sight, Steve is 100% right. The manufacturer gives a guarantee for at least 6 Month because we know from our own test, that the homogenity is one of the most important parameters for a good printability. It could
Electronics Forum | Sun Apr 05 09:25:12 EDT 1998 | Earl Moon
| Dear Peter, | out of the manufacturers sight, Steve is 100% right. | The manufacturer gives a guarantee for at least | 6 Month because we know from our own test, that | the homogenity is one of the most important parameters | for a good printabilit
Electronics Forum | Wed Apr 08 17:42:24 EDT 1998 | Wayne
| For nearly 30 months I have waited on Contact Systems | resolving indexing and clearanceproblems with their | 32mm and 44mm tape feeders. I think that the service | that they offer is pretty poor. | Am I alone? Does anyone else use their larger
Electronics Forum | Fri Apr 03 14:09:50 EST 1998 | Chrys
I'm also in the "Don't score it" camp. Routed breakaways are much better. If your wave solder process has decent control on the wave height, you shouldn't worry about flooding the boards. The fine pitch consideration for panelizing - Since you norm
