Electronics Forum | Thu Mar 12 06:23:27 EDT 2009 | gregoryyork
Thanks Nicoleta It is nice to hear the problem is solved and this is a massive problem in the industry especially for Lead Free. It is easy for a supplier who doesn't understand to blame incompatibility just a quick way out but doesn't fix anything
Electronics Forum | Thu Feb 26 03:26:40 EST 2009 | sachu_70
Hey, changing jobs shouldn't be in blind faith. Whether abroad or in your own country, you always need to do your "homework" before taking such important decision. I have lived in China for sometime and was closely associated with the Electronic Manu
Electronics Forum | Sun Mar 08 11:51:09 EDT 2009 | erhard
Hello, as some guys already pointed out there is some paperwork to do to get someone from Asia to work legally in Europe. But it's not impossible. We got an Assembleon service engineer in from India about 18 months ago, he is still working for us, pa
Electronics Forum | Thu Mar 12 06:37:48 EDT 2009 | gregoryyork
I agree you are too cold for the profile get it up to 230C and possibly allow it to dwell a little longer in preheat as opposed to pushing up the reflow zone only. Sn90/Pb10 melts at 220C so 2C hotter than your profile so you are reliant on it alloyi
Electronics Forum | Thu Mar 26 21:03:24 EDT 2009 | bigdaddysoy9
I have noticed this on some of our large multi-circuit panels. It's such a slight rise in our false call rate that I haven't really explored it. I'm just guessing that it has something to do with the fiducials calculating the twist/shrink of the boar
Electronics Forum | Thu Mar 26 14:18:31 EDT 2009 | avery5931
What do people use to document Work Instructions? > Has anyone used ProWorks (proworksinfo.com)? Thanks guys. I'm assuming you're referring to http://www.aiscorp.com ? Checking out Aegis first, may take a couple days. Valor looks pretty interest
Electronics Forum | Wed Mar 25 14:55:17 EDT 2009 | cyber_wolf
The small x motor quit working.It seems that there is no voltage going to the motor. Here is what I have done so far: *Verified that the motor is good. *Check pico fuses on the backplane *Verify voltages on backplane and on big booster. *Swap mot ca
Electronics Forum | Wed Apr 08 15:16:14 EDT 2009 | waveroom
I would use almost the same profile you use when putting the component down on the board. Your pre-heat is essential in rework. Also even though your machine tells you your at a specific temperature I would add a thermocouple next to the component yo
Electronics Forum | Mon Apr 27 19:31:12 EDT 2009 | stevek
Remember that the 25% is a reduction in cross sectional area. A void in the middle of the ball that reduces the cross sectional area by 25% is about half the diameter of the ball. If it is closer to either termination, the corresponding size would
Electronics Forum | Sat Apr 25 02:46:18 EDT 2009 | smellew
FYI SME offers a replacement Tape leaf detection system which covers the whole range of FUJI CP4-CP7 machines.its also very reasonably priced. It doesn't use Fibre Sensors or mirrors. it only has 1 adjustment which is height via Eccentric screw. even
