Electronics Forum | Fri Sep 20 04:56:17 EDT 2002 | byates
Hire a seasoned SMT process eng and buy used equipment.I would use Fuji. There is a glut of used stuff out there and you can set up a whole line for under 200K. I have done this in the past and have set up over 10 lines myself using different equip m
Electronics Forum | Mon Sep 23 12:27:47 EDT 2002 | dragonslayr
Genny - are you still out there? I'm just a bit curious how your progress has been since your original question was posted weeks ago. It appears you have received a wealth of information. It also is evident that your posting has taken on a new tange
Electronics Forum | Tue Sep 24 13:13:12 EDT 2002 | dragonslayr
thank you Genny for your update. You will find in the future that there are very helpful people and suggestions here for specific issues. I would encourage you not to worry about the nature of the request - general info or specific. In my opinion, th
Electronics Forum | Thu Sep 12 15:23:06 EDT 2002 | soupatech
I amusing a Fuji CP3. The part data seems to be the easiest part for me, 3x3 square. I went with the 2mm and had LOTS of dropped parts. A 1.3mm worked MUCH better, between 1 and 2% loss. My only problem now seems to be profiling the oven. The specs o
Electronics Forum | Mon Sep 09 08:21:37 EDT 2002 | mk
What kind of changes could be expected by changing from a HASL finish to gold? We have a board the had been being coated with HASL but was changed to gold to make priting easier. Now, even though the soldering looks fine, we are getting fallouts at G
Electronics Forum | Tue Sep 10 11:10:08 EDT 2002 | Wang
I wonder if anyone has experience with electrodeposited photoresist, namely PEPR 2400. I have had some problems working with it. If I do not use thickness controller PEPR 2400 TC (active component 2-Octanone), film tends to be thick. I fI use it, fil
Electronics Forum | Fri Sep 13 08:59:17 EDT 2002 | bmulcahy
Hi , Using the Agilis feeders 3/4 months now. We are low volume so they haven't worked hard , but we have had no real problems. They seem to work well with both paper and plastic tapes.As for components we use them on 0603, 0805 ,SOT ,mini-melf & t
Electronics Forum | Thu Sep 12 11:26:11 EDT 2002 | scottefiske
CK, If joints have been validated prior to ICT (under BGA Scope), more often than not repeatable joint fractures are due to undo stress being placed on the component during ICT test. Verify ICT probes and fixture. If after proving out fixture/pin com
Electronics Forum | Fri Sep 13 13:43:48 EDT 2002 | barryg
You right Simon, this forum is not for that type of question, but since you have been polite and desperate, i'll shoot some help. Your right, sounds like it is the unit, there is probably a component failed that is shutting down the unit when it gets
Electronics Forum | Fri Sep 13 14:22:37 EDT 2002 | davef
If that's the case, it's most likely the radio is bad. Again, I'm not clear, but it sounds like using the MD is the trigger to shut the player down: * Stop using the MD. * Fix the MD or some of the associated power supply regulation circuitry. For
