Electronics Forum | Mon Mar 17 09:58:57 EDT 2008 | operator
I do it before the kit hits the floor. Most of the time it is not important have the solder in the pic. If you just need to show orientation etc... I will snap a pick on the first board that gets a wire add or something, but it really only takes 5 mi
Electronics Forum | Tue Jul 29 13:01:57 EDT 2008 | grics
I know your pain all to well. We currently use bmps or jpgs and group them by station (for case assembly) We do this for inspection purposes. Sad truth is most people on the line end up becoming the "sole builder" of the product and decide they ha
Electronics Forum | Sat Aug 02 15:00:12 EDT 2008 | miroyu
I built aluminum cage add ground wire to it but my problem is not gone!Also , video is not in focus.How can I make it right.Does this shows that quadalign board is foulty? Any comments PLS? Thank you Miro
Electronics Forum | Thu Aug 28 21:39:47 EDT 2008 | davef
Shelf life numbers don't mean dip. Are the parts solderable per ANSI/J-STD-002, Solderability Tests for Component Leads, Terminations, Lugs, Terminals, and Wires? If yes, go solder the parts. If no, get better parts from your supplier.
Electronics Forum | Tue Oct 07 12:35:10 EDT 2008 | andy_pal
Hi All, I am using COB on my DOUBLE SIDED PCB. lastly we used Eletrolytic Ni / Flash Gold Plating. Our Boards vias Failed the UL corrosion Test. we did some cross-section analysis and found 10.75 �m of Nickel and 0.022 um of Gold and as the Process
Electronics Forum | Wed Oct 22 12:46:05 EDT 2008 | hussman
Wire wheel works too. Pre tin the part. Hand solder after reflow. Or order good parts. I prefer the last one. Hows that for an answer?
Electronics Forum | Thu Oct 23 16:31:50 EDT 2008 | blnorman
Bodycote is an independant test lab that can run ICP impurity analysis. We used them a few years back to evaluate 2 different bar and wire suppliers.
Electronics Forum | Mon Nov 24 14:45:29 EST 2008 | wavemasterlarry
What?!?1?!? I use the same oven for both. Doesnt' effect anything cause everything taste OK. Gotta be carefull of wires cause they can burn and catch fire. Speaking of, time to hit the bar.
Electronics Forum | Thu Dec 04 15:40:05 EST 2008 | dougt
Do a search here for SMEMA standards, I had problems a while back and had to swap some wires on an OEM's machine to get it to interface correctly to our equipment. Probably not the same problem as your having but I did write a long winded explinatio
Electronics Forum | Thu Jan 15 21:16:18 EST 2009 | davef
Our first impulse would be to blame someone else. We'd send some of the DPAK from inventory to: * Supplier * Outside failure analysis laboratory ... for delidding and analysis
