Electronics Forum | Fri Sep 30 07:15:17 EDT 2011 | deanm
We are using Kester 985M in our Pillarhouse Jade. We only run SnPb, but this is a newer formulation of flux that is suitable for both lead and lead free alloys. Call the manufacturer of your selective soldering machine and get their advice. They ty
Electronics Forum | Thu Sep 29 10:34:46 EDT 2011 | leemeyer
I recently bought a used Universal conveyor #5362I. All I need it to do is pass through boards from 1 machine to the next without operator intervention. The only way I can get it to accept a board from the upstream machine is by pushing the yellow bu
Electronics Forum | Sat Oct 01 09:15:23 EDT 2011 | whitewing
If they sold you the lens and refuse to support it I'd demand your money back. I'd never deal with a company with this sort of policy - who would buy new kit knowing that the potential resale value is decimated by the manufacturer's policy of ripping
Electronics Forum | Sat Oct 15 19:18:14 EDT 2011 | enttec
Hi Does anyone have a calibration manual for a MPM AP25-Hie ? Have noticed recently that we have a slight mismatch between board and stencil when printing. I have the user manual but we didn't get calibration when we bought this machine Thanks Nic
Electronics Forum | Mon Oct 17 10:14:32 EDT 2011 | swag
Do you have cal. fixture(s)? If not, one 1/2 baked way to get yourself closer quickly is to go into your programs and write down your x/y offsets that you've gained during vision offsets while in production. Compare them - hopefully they are very s
Electronics Forum | Thu Oct 27 16:04:05 EDT 2011 | sjs2303
Right folks, i'm sure we have a wealth of experience on here that needs to be tapped into! If you had to give on piece of advice to a fellow SMD operator/production engineer what would it be? I'll get it started, for me you must not over edit packa
Electronics Forum | Fri Nov 11 15:04:31 EST 2011 | cnotebaert
Thanks Dave, I had found this in the past, I was looking to see if someone had already developed a straight forward simple program that outlined what needed to be handed to the end customer (well my end customer). we are finding it very difficult to
Electronics Forum | Sat Oct 29 12:53:34 EDT 2011 | dontfeedphils
We had the same motor problem with our My12, whenever we would get the sound we would go through and slow down X accel speed in any packages and the placement accuracy as well. After doing this for quite a while we finally tried updating the motor c
Electronics Forum | Wed Dec 07 13:31:29 EST 2011 | rway
So are you more concerned with cleaning the board than fixing the issue? Are you employed by the OEM? If so, your main concern should be to eliminate the cause of the contamination which sounds like it's coming from the board house. But if you are
Electronics Forum | Mon Nov 14 10:46:48 EST 2011 | dyoungquist
Have you tried an ultrasonic water cleaning process? We use an ultrasonic cleaner with tap water and Omega Aqua Clean LPH cleaner (omegasonics.com) then rinse with DI water. However, our cleaning requirements are not as strict as yours are from the