Electronics Forum | Fri Jan 09 23:53:48 EST 2004 | Dean
How high are we talking? 1000 Celsius? KIC Thermal Profiling double sided aluminum profiling tape. I have used at an extreme application of 240 to 300 degrees celsius for 18 minutes. With up to 30 passes with no visible degree of deterioration.
Electronics Forum | Mon Mar 22 15:49:40 EST 2004 | Frank
You can also do what I was doing before we found the one at Nix. We simply used double-sided tape and taped the carrier tape down on to the floors of the tray tower. Can't get much more 'simpler' than that!!!
Electronics Forum | Wed Apr 28 09:55:18 EDT 2004 | vms
Hello There is several ways of placeing board supports. It's easier to explain this over the phone. If you would like to call us we would be willing to go over it. 740-344-4260
Electronics Forum | Fri Apr 30 13:49:52 EDT 2004 | Chris Lampron
We are using these and are very happy with the results. http://www.production-solutions.com/Inline.htm Good Luck Chris
Electronics Forum | Wed Jun 23 08:01:37 EDT 2004 | Ordie.
How many boards? What type of components? Surface mount, through hole or both? Single sided or double? Any surface mount or through hole pins? Ect.
Electronics Forum | Wed Sep 08 07:06:36 EDT 2004 | peter016
Hi Rob, Thanks for the reply. Our boards are 4 ~ 6 ups and mostly double sided. The ratio between chips and IC/Odd shape varied from products to products. So, line balancing between chipmounter and GSM is tough to do. Some boards are mirror image to
Electronics Forum | Sat Nov 13 00:50:05 EST 2004 | KEN
Place the part on a board with double sided sticky tape. I bet the part is sliding around AFTER mounting. The tape would proove this. Also, are you sure your not dragging on the scrap counter? Maybe the height of the part is just touching the un
Electronics Forum | Thu Mar 17 10:30:06 EST 2005 | davef
This happens. You may need to put a dot of chip bonder on the corner of the floating QFP after first pass. What size are the QFP that are moving?
Electronics Forum | Thu Mar 17 10:34:34 EST 2005 | Rob
Or... If you have an inline glue dispensor, after printing put a glue dot in the centre of the footprint & this should hold it. Rob.
Electronics Forum | Mon Mar 21 10:34:02 EST 2005 | py (france)
it's definitively not possible.. printer/chip shooter/pick and place/reflow and printer/chip shooter/pick and place/reflow.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830