Electronics Forum | Thu Aug 26 09:44:45 EDT 2010 | smtmfgeng
Hello all, I have a few CP43's and am struggling to find their air consumption ratings. I found that our IP3 consumes 240 Nl/min for the machine itself, and the MTU unit consumes 600 Nl/min, however Fuji's spec sheets do not list these ratings for t
Electronics Forum | Wed Sep 01 08:54:25 EDT 2010 | fedorend
Hi Namruht, One question, what exactly are you > wanting to achieve using "feeder calibration? In > what way would feeder calibration make these > feeders (between Siemens and Universal) > compatible? Or maybe i misunderstood your point > .....
Electronics Forum | Mon Aug 30 10:17:16 EDT 2010 | markgray
We currently use this devise in one of our designs with no issues. We are using a 3mil stencil and a 45% apperature reduction. It is virtually impossible to eliminate voids but they are in an acceptable range. Solder balls are caused on this componen
Electronics Forum | Mon Aug 30 08:57:54 EDT 2010 | stevezeva
Hi Stephen, Once they've been soldered down, you're stuck with doing touch labor on each and every one. But you might be suprised how quickly this can be done with the right tools. Are they all the same value resistor? If so, that should make things
Electronics Forum | Thu Sep 30 21:01:05 EDT 2010 | globalsmtservices
Hi, We deal with Siemens Siplace parts and we have some cameras on stock. Please let us know if you still need a camera and I will send you a list with some of the ones we have and prices. We may also be interested in a swap with your flip-chip came
Electronics Forum | Thu Sep 02 19:22:08 EDT 2010 | fulldrawmike
seen it on a uni-mod many times. there is a muffler near that assy that if dirty will cause the air dump to back up and not exit out the muffler. if yours has one, remove it and see if it stops the table latch. it will be loud but it will let you k
Electronics Forum | Wed Sep 08 14:12:48 EDT 2010 | namruht
We just purchased a 1100D and have been using it for about a month. It seems to be a very easy and simple machine to setup and use. It is the only one that I have experience with and so far I really like it. Do make sure that you know how much carrie
Electronics Forum | Tue Sep 14 17:08:58 EDT 2010 | daxman
Hi, Do you have an Xray machine? we've had similar problems with micros in the past. I'd place one on double sided tape and x-ray to ensure that it is centered. If it is, i'd look into other issues such as vibration or speed of the PCB in the machin
Electronics Forum | Fri Sep 17 01:19:02 EDT 2010 | sachu_70
I suggest you have a look at the method and detergents used during cleaning / washing these smocks. This would help to understand if the smock properties deteriorated on account of such process. In addition, you could keep one unused sample for over
Electronics Forum | Thu Oct 21 11:15:00 EDT 2010 | jorge_quijano
Do you know in which axis the problem occurs? usually when "hardware limit error" shows is because one of the axis touches the sensor of the limit, this is to prevent the mechanism hit something, If you machine is used, you can check if there is a mi