Electronics Forum | Wed Nov 14 20:28:24 EST 2001 | davef
Not to worry. Just run the boards through the cleaner. It will remove all the solder balls. The gross filter on your washer will collect all the solder balls. Coo eh? ;-) How to cure SM? Is your mask UV, er thermal? After learning the type, you
Electronics Forum | Mon Nov 19 20:15:39 EST 2001 | davef
Now, that is one thickass board!!! The rant first: If our �board supplier changed our board surface finish on� anything without our approval, the board supplier would be an �X�. Life has enough surprises. And of all the flat finishes available, h
Electronics Forum | Thu Apr 11 19:12:11 EDT 2002 | djarvis
Sorry fellas -disagree. We only clean our stencils in the ultrasonic machine at the end of the run. If the same pcb is up the next day we clean them by hand. We use Electrolube SSS and the used rolls from the in line under stencil cleaner. Wipe the
Electronics Forum | Thu Dec 06 23:34:25 EST 2001 | Beny
Pls. help. I�ve problem with non-wetting defect at capacitor termination. I have faced this problem at the 2 kinds of termination. One is chip capacitor 0603 that its outer termination surface composed with 100 Sn (Lead free) and another one is Sta
Electronics Forum | Wed Jan 30 17:44:38 EST 2002 | davef
The gold is compatible with your solder. Gold will dissolve in your solder very quickly. Assuming you have a fairly large [~ couple hundred pounds] solder pot, the gold will not, over the short term, affect the performance of the pot. The issue is
Electronics Forum | Thu Feb 07 09:07:10 EST 2002 | fmonette
Dason, Please be aware that weight gain is only a very crude estimate of the component moisture content. This is only accurate when the moisture is uniformly distributed inside the component (which is actually never). This measurement is usually no
Electronics Forum | Fri Jan 10 15:02:03 EST 2003 | John
Hi. I am familiar with the Transition blades. Normally, when there is metal to metal contact, as in the squeegee-stencil situation, there will be scratches, or a "brush pattern". Sometimes it takes the pattern of the high profile surface elements u
Electronics Forum | Thu Apr 11 18:47:43 EDT 2002 | slthomas
A couple of questions to establish a baseline for when the check writers start asking questions........ How many of you have vision systems on site for BGA inspection? If you don't have it, do you do 100% X-ray, or did you just nail down the proces
Electronics Forum | Tue Apr 16 13:59:33 EDT 2002 | paulausten
They work great as long as your conveyor speed > has been calibrated and checked on some type of > PM schedule. On some oven types these sensors can > warn you to possible problems with the conveyor > speed. Say the oven is calculating that the b
Electronics Forum | Tue Apr 23 12:17:28 EDT 2002 | binns
I have a couple of questions for you, and a couple of answers. 1. Which model ? (100, IIc, IVc, QSV, QSP ) 2. In reference to how the machine stacks up with Fuji and Panasonic. They have never stacked up. Those families of machines have historicall