Electronics Forum | Tue Nov 09 10:44:13 EST 2004 | russ
I guess i might want to throw this in for future reference. After speaking with our board supplier he states that this mask is fully cured when it reaches approximately 180C. I beleive this since we usually probe the repaired area after putting the
Electronics Forum | Thu Nov 11 02:59:03 EST 2004 | Base
Hi Charlie, In case you're processing large quantities of lumileds you may want to have a look at the Assembleon FS machine. It is an FCM machine of only half the length with some dedicated robots on it. In stead of all Pick&Place robots it 2 dispen
Electronics Forum | Wed Nov 10 20:32:59 EST 2004 | Fengang
Hi Dave, Thanks for your reply. I have checked the former thread you gave to me. But I think it's totally not the same thing. I want to know, when we see the component spec -- 260 centigrade 10secs, the 260 centigrade means what? It's the environme
Electronics Forum | Wed Dec 01 19:21:15 EST 2004 | cmiller
You can make one out of a stainless steel tank pretty easy. Cost maybe $1000.00. You will need some hot plate type heaters and some copper tubing with a water flow source to keep the vapor down in the tank. We used two fluid types so one blanketed t
Electronics Forum | Wed Nov 10 18:12:49 EST 2004 | dorklover664
We are looking for a new way to support PCAs in the DEK. I am trying to push for getting grid-locks but have been told they cost to much. Right now we are trying out another support system (hell if I can remember what they are called) like the grid-l
Electronics Forum | Thu Nov 11 11:22:29 EST 2004 | clampron
We are using the Red-E Sets on our DEK Infinities and they are working fairly well. There are some issues but the setup time beat the Form Flex and was more reliable than the Autoflex in our machines. We looked at Grid Lock. This seemed to solve all
Electronics Forum | Thu Nov 11 13:34:44 EST 2004 | dorklover664
Did you like the FormFlex tooling as far as support goes? I would be more inclined to spend the set up time if we got better support. As of now we have about 30min, between runs so the set up time isn�t as important as the cost and the support is. We
Electronics Forum | Thu Nov 11 14:40:43 EST 2004 | no gel pig fan
We worked with 3-4 revisions of the form-flex and they all had problems with stuck pins or pins that just wouldn't come out (due to leaks). The Form flex was pneumatic and hydraulic and worked well for awhile (2-3 weeks)but never seemed to last much
Electronics Forum | Fri Nov 12 08:02:07 EST 2004 | no gel pig fan
I would get a demo set of the form flex (they will probably give you it for at least a few weeks hopefully a month) and check it out. They could be much more reliable than when I tested them. I would definately take a working form-flex over a working
Electronics Forum | Sun Nov 14 17:29:57 EST 2004 | donb
I'm glad I dropped in here. I am about to buy some tooling for a Fuji GP-641E. I have been told to get the Red-E-Set, but from this discussion I'm not sure if that's a good idea. The local dealer wants US$1000 each for the 24" segments, we would pro
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, USA
Phone: 18002796835
