.gif)
Electronics Forum | Tue Apr 08 22:55:01 EDT 2014 | padawanlinuxero
Hola Beto Here we use this one CAB MAESTRO 3E it's ok does the job well and both blades can take a beating before need to change them. http://www.cab.de/en/electronics/pcb-separators/maestro-3e/ Saludos Beto
Electronics Forum | Fri Apr 11 16:14:41 EDT 2014 | superlen
I just noticed that under the print utility you can in fact Print To File, (disregard my earlier note about needing .pdf print driver) so this would give you an ascii ouput of the optimized feeder list. However, you still have to do it at the machine
Electronics Forum | Fri Apr 11 18:06:10 EDT 2014 | sarason
Lenny send me some .opt and .pcb files with the original Altium or CSV file and your generated SSA file and I will reverse it out for you. It should take me only a little time. My email is on my webpage http://members.iinet.net.au/~sarason/ saraso
Electronics Forum | Thu Apr 17 07:51:19 EDT 2014 | emeto
Opens are on the device to the PCB - mainly on the edges, that makes me think I get some kind of warping,but even if I bake parts and boards doesn't help. We also tried different reflow profiles - same results. I hear that some people use dip fluxers
Electronics Forum | Mon Apr 21 16:38:45 EDT 2014 | barryg
Hello all. We have been having some problems soldering to what we believe is a nickel plated spring steel battery terminal to a PCB. We have tried scrapping , then tinning, dipping and still have problems. Are there any special fluxes or pre-treats t
Electronics Forum | Wed May 07 08:16:58 EDT 2014 | emeto
It really depends on pad design and other component on the PCB. Most of the time I run 0201s I have microBGAs on the board and usually print 3mil. Reduction will depend on the paste. For leaded paste you will have reduction (about 10% or so).For Lea
Electronics Forum | Thu May 15 09:55:16 EDT 2014 | julianf
Tmo, Thanks for your reply. It gives good advise about how to perform tests. The type of strain gauges that I want to design are inside the PCB at various layers and I want to read the data during the press step. Do you know if these prefabricated
Electronics Forum | Tue Jun 03 10:28:09 EDT 2014 | swag
Incoming inspection: Look for flaws and measure position of v-score as well as depth. If v-scored on both sides of panel, make sure v-scores are in alignment. Follow the PCB thru all processes inspecting after each stage of processing, especially
Electronics Forum | Sun Jun 29 07:31:03 EDT 2014 | vitrost
Hi, We had experienced very similar issue on boards of a certain PCB manufacturer. Field experiments showed that the solder mask of this manufacturer is prone to swelling and peeling after it was in contact with our water-based flux. When you switc
Electronics Forum | Fri Jun 06 06:11:18 EDT 2014 | paulg
I have a large monoblock ceramic filter on a PTFE based pcb material. The filter has a metal casing soldered onto the ceramic filter. I am concerned that if the heating rate is to rapid, then thermal shock / differential expansion could cause the fil
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, USA
Phone: 5102268155
