Electronics Forum | Wed Jul 12 17:17:04 EDT 2006 | fordf1502004
I want to thank you for your help. after further investigation into the panasonic machine one our technicians was able to fix the issue. The panasonic machine uses a 5 volt signal and normal smema uses a 24 volt signal. To make these 2 machine talk t
Electronics Forum | Wed Jul 12 16:39:59 EDT 2006 | SWAG
Can anyone help point me in the right direction on fixing problems related to the following Universal GSM2 errors?: 1) Axis head 1 Z position following error during Move Absolute command. 2) Axis head 1 Z error not recognized during Move Absolute
Electronics Forum | Thu Jul 13 13:51:13 EDT 2006 | George
I got some info about it last year. I could not justify ROI since this machine was way too expensive (same thing with Vitronics Selective machines). You need to see if this machine will increase your throughput or not depending on your products. Al
Electronics Forum | Mon Jul 17 11:19:46 EDT 2006 | Chunks
Never seen a direct study on these two correlation�s before. But if you have moisture sensitive devices, higher humidity could have some affect on them. If you are talking regular Rs and Cs over wave solder - I kinda doubt it. Water based fluxes d
Electronics Forum | Thu Jul 20 05:04:30 EDT 2006 | bing007
We had a similar problem with gold contact pads. Cleanliness is paramount. If you are using foil tensioning system, wash the foil in a stencil wash before use as the cardboard cassettes may be contaminated. Be very careful when loading into a frame f
Electronics Forum | Wed Jul 19 21:11:40 EDT 2006 | ec
Hi Dave, Sorry that I did not explain clear enough. What I mean normally after reflow, the solder joint is very smooth and there is wetting. But now we see there is hole on the solder surface and is not on the same loaction. This product have been r
Electronics Forum | Tue Jul 18 15:47:07 EDT 2006 | Mark
IPC610 training to help verify issues that might arise. Also, the opeators need to know part numbers and descriptions because that should be common knowledge when running a SMT line. Plus, with your comment "At our company they know how the pick&plac
Electronics Forum | Tue Jul 18 19:09:12 EDT 2006 | SWAG
Our lines have operators on all shifts capable of doing programming start-to-finish and can deal with almost any program related problem. We are high mix, low volume. Our builds are sometimes one of a kind with qauntities of 20 or 30. We empower a
Electronics Forum | Tue Jul 18 23:11:03 EDT 2006 | Utog Oten
Hello folks I am seeking advice and guidance on a screen print machine who the best manufacturers are of this equipment and so fourth. I got budgetary approval from the management to purchase a medium volume electronics line. Our engineer sup. seems
Electronics Forum | Thu Jul 20 11:18:43 EDT 2006 | ev
Paul, the error says "MOT1-38-247 MSETDYNX: Xwagon fan not working." I have checked...the X motor fan and it is working...the fan behind the PAIB board is also working...I checked this because there is a connector marked X wagon fan on the PAIB boa