Electronics Forum | Sun Sep 18 06:17:40 EDT 2022 | poly
I'll double check tomorrow but I don't think so, it fails zeroing straight away (without moving the other parts) when the PWC axis is enabled, which is why I tried swapping the board as I assumed it was a controller not being found issue.
Electronics Forum | Tue Oct 18 12:21:40 EDT 2022 | cyber_wolf
I have very limited experience with agilis but I know they use them currently. I am definitely not a fan of the older Hydra heads. There were many problems with them mechanically and with the camera.
Electronics Forum | Thu Dec 22 15:11:40 EST 2022 | jbrochecouste
hello, I am looking for information on the following error message: F-MOT-MSETDYN HYDRA Z/156 / TIMEOUT... on a MY12, tell me your experience until the problem is solved
Electronics Forum | Mon Jan 23 21:45:40 EST 2023 | stephendo
Have you looked at simple solder fountains? If it is just simple connectors that might be all you need. Or maybe a small wave solder machine?
Electronics Forum | Tue Feb 28 11:14:40 EST 2023 | dontfeedphils
Juki should have a system like that. Pretty sure it's a part of the IS suite of software, but it's been 6+ years since I've dealt with Juki.
Electronics Forum | Mon Apr 03 16:41:40 EDT 2023 | dilogic
Well, this is a very odd bug - it turned out one of capacitors, defined as a no-lead, had pin definition changed to gull-wing! Interestingly, if that part was located on Head1, it won't cause machine hang-up...
Electronics Forum | Fri Jun 16 17:42:40 EDT 2023 | robertobsuinc
Hi, Is there any accesory we can get from my data to place caps vertical on the board but are horizontal in the reels? Is taking to much time hand placing the parts, we would like to automate
Electronics Forum | Tue Jun 20 13:45:40 EDT 2023 | emeto
All you need is a calendar setup of any kind to remind you. You can also use it to acknowledge the maintenance happened for audit purposes. All the detail should be with the maintenance manuals.
Electronics Forum | Thu Jun 29 16:15:40 EDT 2023 | bobpan
The amplifier has probably gone bad. I have had to replace a few over the years. Swap it with another machine if you have one. good luck
Electronics Forum | Sat Jul 08 02:21:40 EDT 2023 | unsung
I did clean the gold strip and black encoder box pretty good it took me a few trys but it work ( it did had rust on the machine from the rain I guess... from being out side for awhile)