Electronics Forum | Mon Apr 02 10:20:40 EDT 2007 | realchunks
Hi Chris, Yes, my hand is up. But the problem is WHY you are stock piling printed boards. Is it a single printer used to feed various lines? I would think that since you are hand placing parts, that this printer would be able to keep up. Obvious
Electronics Forum | Thu Apr 26 11:40:10 EDT 2007 | CL
Good Morning, We have a 3D solder paste inspection machine. We purchased it on a recommendation from a consultant. We are a CM high mix low volume. The President of my company has attended some seminars and meetings where it was conveyed to her that
Electronics Forum | Wed May 30 22:09:31 EDT 2007 | jeffreys
I'm trying to find a solution that will clean our PCBAs that will meet the following criteria: 1. Low cost 2. Enable us to clean 25 - 100 PCBAs per day 3. Leave boards clean, including residue removal 4. Preferably environmental friendly 5. should b
Electronics Forum | Wed Jun 06 10:41:30 EDT 2007 | rgduval
I think everyone has experienced this issue at one time or another. We receive or design one-up's, and let the board house recommend panel size. Unless there's a process specific reason for us to define the panelization. We then approve the array
Electronics Forum | Wed Jun 06 10:56:01 EDT 2007 | SWAG
Sounds familiar. We are trying to get credit for a bunch of boards at this time based on the gerber we approved - not an official print by any means. Unfortunately, we are stuck with the paperwork trail and the 38 junk boards that were ruined in ma
Electronics Forum | Fri Jun 15 12:12:34 EDT 2007 | realchunks
Hi Ed, It all depends on more info needed. How many preheaers do you have in your wave? One, two, three? Are you talking bottom side preheat? What size boards do you run and what type of parts are on it. Typically, preheat does several things; w
Electronics Forum | Mon Jul 16 10:44:29 EDT 2007 | Jacky
Hi All, Recently, we encountered strange defect at our SMT line. We can see solder ball spatter around at one of the component pad. This lead to insufficient solder defect at 1 side of the component. The other side of the component look good(Meet
Electronics Forum | Mon Sep 24 07:38:01 EDT 2007 | chrispy1963
I never saw in any post if your machine uses the camera to find the board edge or if your machine uses the bottom front rail mounted board stop sensor. Also is this with only one particular job you run on this machine or is this happening with ALL
Electronics Forum | Fri Dec 28 14:31:42 EST 2007 | clampron
RC, I agree. I have tried to educate management as to the real benifits of height measurement. Our President attended a CEO meeting of some sort and was told that solder paste height measurement will solve all of the worlds problems. She then inquir
Electronics Forum | Tue Jan 15 15:53:14 EST 2008 | jmelson
I only build my own products, so it has to meet my needs for QA only. I am doing some 20 mil lead pitch (0.5mm) and will soon be doing a 0.4 mm pitch part. I have more magnification on my microscopes (40X) but almost never need to go that high. If
