Electronics Forum | Wed Jul 06 20:05:02 EDT 2011 | rickysanchez
we are using the silicone Dow Corning JCR6101UP. we use it to coat the whole die including the wires.
Electronics Forum | Mon Jul 18 14:37:33 EDT 2011 | ldavis
We use the same profiler for convection and VP. For VP you just have to be very careful as the thermocouple wires must travel through the machine so cannot get "snagged" on anything as they go in or come out.
Electronics Forum | Tue Oct 11 11:17:04 EDT 2011 | adp23
are you familiar with UL 796, Printed Wiring Boards i believe they discuss some standards and test procedures regarding conductor material, and solder material but im not sure if UL actually lists solder material by it self.
Electronics Forum | Tue Jan 03 13:45:14 EST 2012 | adlsmt
What would be the best router to use that would allow clearance on the top side for large components and long wires on the top side of the board? High volume so must be fast.
Electronics Forum | Sun Feb 12 03:06:04 EST 2012 | dan_ems
Please help me with this: I need a zero Ohm SMD resistor (strap) to connect 2 PCBs but to be like a wire, that can be bent. I need to be SMD because I want to be place it with "pick and place machine". Thank you.
Electronics Forum | Thu Feb 23 16:31:09 EST 2012 | hegemon
Could be as simple as a pail full of UR coating and some wire hangars! Conformal coating is brushed on, sprayed on, and parts are dipped too, not to mention the wonderful vacuum process that is paralene. Gotta have a little more info as to your a
Electronics Forum | Tue Jun 05 06:37:48 EDT 2012 | mosborne1
Definition: Pink Ring - A condition that can exist in multilayer printed circuit or wiring boards, in which the oxide around a through-hole inner layer interface is chemically removed, and there is a lack of adhesion of the inner layer to the dielec
Electronics Forum | Sun Jan 27 11:28:42 EST 2013 | mdang
Could anyone help to connect a FUJI CP42 machine to a conveyer with stanard SMEMA? CP42 has 2 wire cable and small female connector label SMEMA (Not fit with stanard SMEMA). Thank you for all your help, -Michael
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Mon Feb 25 22:57:31 EST 2013 | mdang
Hi Sr Tech, As you suggested, I tried with different AMP and it is display from 0 to 9 when I rotate the FRQ motor. I am going to replace the HPX-T1 AMP. Would you cut the wire or trace it to back to replace it? Thanks, -Michael