Electronics Forum | Tue Aug 10 15:56:30 EDT 1999 | Jason Gregory
Has anyone ever heard of this? I have a Camalot System 5000 and we were in a pinch to produce some prototype boards. We needed Sn62Pb36Ag2-no clean in a dispensing mesh. All I could get my hands on was some Interflux paste in a jar. The formulation i
Electronics Forum | Thu Mar 25 14:00:45 EST 1999 | Bob Willis
| Rob, | | We are also using intrusive reflow to simultaneously process SMT and Thru-hole components. Our arrangement goes as follows: | | - Screen print solder paste to the single sided PCB using 0.008" laser cut stencil. | - Apply adhesive dots
Electronics Forum | Fri Mar 06 23:13:13 EST 1998 | Scott Cook
| We have a double sided pcb that is surface mount on both sides. Now a Through Hole connector has been added. Appart from hand soldering does anyone have info. on reflow soldering the part. The connector is 0.1mm pitch, square legs. | 1) Do you need
Electronics Forum | Thu Apr 11 20:35:22 EDT 2002 | davef
Messy. Messy. Messy. Consider gluing these components, until you control your process. It is unclear to us that a single factor drives these defects, but multiple factors that need to be tuned to work well together. PAD DIMENSIONS * Some SM-782 pa
Electronics Forum | Fri Apr 26 10:42:28 EDT 2002 | Jim M.
I worked for a telecom company that had sites in the deserts, jungles, mountains and regular built up area's. All boards were built using Aim 291/293 No clean solder paste. (all boards built to Bellcore standard) The boards were coated with Dymax ur
Electronics Forum | Thu May 30 13:46:00 EDT 2002 | davef
Consider NOT getting involved in those little POS chunks of sheet metal. * They're expensive. * You never have the one you need. * Even if you DO have the item you need, you probably will not be able to locate it. * It's all but impossible to c
Electronics Forum | Sun Nov 24 09:54:24 EST 2002 | davef
On a HASL board that has poor wetting on the pad, consider looking further downstream in the process than your assembly shop. For instance, take a look at the bare boards. Look for solder mask bleed onto the pads. This will show-up on the outside
Electronics Forum | Thu Nov 11 10:09:06 EST 2004 | D.B.Davis
Dear Colleagues, I am working with a new prototype product that is presenting some interesting problems. My Engineering Dept. has made some suggestions that I find a little odd. I am looking for some confirmation from fellow SMD personnel as to the
Electronics Forum | Fri Apr 25 11:38:22 EDT 2008 | vortex337
Our company has run into an issue with de-wetting of lead free components. Our profile is dead on with paste manufacturers specs. We have had this issue with both gold immersed, and hot air leveled boards. We have tried three different solder paste m
Electronics Forum | Tue Dec 16 22:09:36 EST 2014 | deanm
The critical operations where cross contamination can occur is the paste printer, the touch up station and the hand soldering station. Hand insertion should not be a problem if the parts are kitted or issued with proper control. If possible I would
Capital Equipment Solutions - SMT | PCBA | TEST
Equipment Dealer / Broker / Auctions
113 S Main Street
Lodi, USA
Phone: 6083431779