Electronics Forum | Mon Apr 08 17:27:36 EDT 2024 | kingkelvin
I found a 0.9mm hex tool - but if I adjust the indicators "all the way up" on the shaft I get all current ranges at 255 (so obviously too high on the shaft) but if I place it anywhere else on the shaft (slightly down from top, or all the way down as
Electronics Forum | Wed May 15 08:06:09 EDT 2024 | james2024
Hi, It's not on your list, but we use an SPI and an AOI from SAKI. Very simple software interface and the same structure on all machines. As soon as the library is set up, a program can be created in a maximum of 20 minutes. The program creation go
Electronics Forum | Sun Oct 08 17:18:31 EDT 2000 | Scott
I have a problem, I have a radio control unit, which I need to power some low voltage lighting, the radio control unit is also used for two other items so I need to use it, the problem is that the current spike that is required when turning on the lo
Electronics Forum | Wed Oct 04 14:54:46 EDT 2000 | Sean
I feel Woldgang poses an interesting question. It seems you have already decided that dispensing is the path you wish to take. Yet can you tell us why? Is there a flexibility vs. throughput arguement here? Justification of dispense via the cleani
Electronics Forum | Thu Mar 16 14:04:14 EST 2000 | Cartman
Greetings. My company has a VOC-Free no-clean wave solder flux with 4% solids. I have a number of questions as they relate to our ICT Fixtures. Currently, we're encountering the following issues: 1.) PM on probes....What is the recommended PM p
Electronics Forum | Wed Feb 07 21:56:00 EST 2001 | davef
Every critter out there with large incisors adapted for gnawing and nibbling has a different theory of solder ball formation. [My theory: It�s punishment for using NC fluxes. Stand and deliver. My solder balls end-up in the gross filter connected
Electronics Forum | Wed Mar 28 18:23:48 EST 2001 | Mike Konrad
Hi Bill, Please let me refresh your memory� On April 1, 1999, the United States Environmental Protection Agency sent you a letter based on what they called �inaccurate� statements made by SmartSonic (ironically on SMTNET.COM). EPA letter dated Apr
Electronics Forum | Wed Mar 28 20:03:33 EST 2001 | Rob Fischer
This is brutal. I think we should call a truce. Mike has very good points and his quotations from the EPA letter are fact. If there isn't a competitor of Bill's who hasn't seen this letter I'd be surprised. We could go on and on about this and th
Electronics Forum | Thu May 24 16:45:57 EDT 2001 | kmorris
Hi All: We�ve got a problem here with opens on bottom side wave soldered SOT23s. Based on past experience and review of the SMTnet archives, I feel that our main problem is pad size. We have the same size pads for bottom side SOT23s as we have for
Electronics Forum | Mon Jun 18 13:29:34 EDT 2001 | nifhail
What is the recommanded profile for board which consist of 0402 & 0201 comps. to reduce the effect of tomb-stone. Slow ramp rate ? how slow is considered as slow. Soak time 60 or 120 C,at which end should I stick to? what is the best time before reac
