Electronics Forum | Fri Apr 16 11:07:53 EDT 1999 | Vic Lau
| | We process both tin/lead plated boards and gold plated boards in our surface mount group. I have used Sn62/Pb36/Ag2 solder paste on all gold plated boards to help prevent gold scavaging. To reduce the amount of different solder pastes we have t
Electronics Forum | Thu Apr 22 09:28:22 EDT 1999 | Michael N.
Well Dave what are pads on the ceramic board is composed of is Paladium Silver but it is on the bottom, then comes the copper, then it is coated with tin, then it is coated again with nickel. What makes it even harder is that are devices are Gold lea
Electronics Forum | Tue Apr 13 09:11:54 EDT 1999 | Dave F
| We process both tin/lead plated boards and gold plated boards in our surface mount group. I have used Sn62/Pb36/Ag2 solder paste on all gold plated boards to help prevent gold scavaging. To reduce the amount of different solder pastes we have to
Electronics Forum | Mon Nov 26 09:33:49 EST 2018 | charliedci
The problem you create by soldering from solder destination side (presuming you have already soldered from other side) is that you will trap air in PTH so you have virtually no continuous solder in PTH from one side to other. This will not meet IPC-A
Electronics Forum | Fri Nov 30 12:21:26 EST 2018 | davef
Three things ... 1. Since you are soldering a component over a hole that limits the possibility that the hole could be filled with solder, it makes me wonder if the hole is supposed to be filled with solder. What do the engineering notes say? 2. Ta
Electronics Forum | Thu Nov 29 22:51:18 EST 2018 | jandon
IPC J-STD-001F: 6.2.1 Solder Application: Solder shall (N1D1D3) only be applied to the one side of a PTH except for intrusive soldering. Heat may be simultaneously applied to the both sides of the PTH.
Electronics Forum | Thu Nov 22 23:46:27 EST 2018 | jaypark
Some PTHs on a board in the product I am building are not filled enough to meet the IPC-610-F requirement(at least 75% vertical fill) . I have no access to the solder source side due to something installed right beneath it. In order to completely
Electronics Forum | Fri Nov 23 11:40:21 EST 2018 | dalsenkenneth
I hope someone would be able to help with this.
Electronics Forum | Wed Sep 26 12:16:44 EDT 2012 | bwjm
Hi Guys,recently i am facing an issue. Refer to the attached photo. This PCB is high RF speed, gold immersion single layer. After reflow, my solder seems to have black stains on it. I tried with SAC305 paste water soluble and no-clean, both results a
Electronics Forum | Wed Jun 30 17:58:01 EDT 1999 | Boca
| My guess would be trapped flux continuing to be active after soldering. Is the tarnish there immediately after exiting the machine? Do you remove the mask and wash right away? If the solder is reflowing under the mask on the component side it wo
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
