Electronics Forum | Wed Jul 25 13:29:24 EDT 2007 | realchunks
Hi Lloyd, Homeplates will get rid of solder balling. They are only recommended "backwards" for 0402 or smaller (Points point away from each other). If you do this, you will have a full pad width of paste on the pad for the part to stick in. Obvio
Electronics Forum | Mon Aug 06 15:34:34 EDT 2007 | Hussman
I assume you are ref to top side wetting. In that case you may need to spray the top side of the board with flux to get it to fill. I would suggest ceaning the board afterwards. And yes you can rerun boards through the wave several times. Most pa
Electronics Forum | Wed Aug 22 16:11:15 EDT 2007 | razor1
If the problem appears to be random... we had a similar problem. We found that the belt which feeds the PCB through the reflow oven would jump or lurch ahead. It was barley noticeable but if you have identified the frequency and time of the compone
Electronics Forum | Wed Aug 22 16:23:06 EDT 2007 | rgduval
I had the lurching issue...turned out I needed to readjust to cog wheels on the exit side of the oven. The cogs had slipped, and the chain was actually getting caught in the teeth...to the point that as the wheel turned, the chain would stay in it i
Electronics Forum | Fri Aug 10 16:39:39 EDT 2007 | ratsalad
The parts libraries are not readable text. The Sanyo software we used (UCT, I believe) would optimize the program for you. NCZ format is different than the 4785 .800 format, but if you can understand the 4785 format you won't have any problems
Electronics Forum | Mon Aug 20 10:03:48 EDT 2007 | slthomas
Wow. Never have, never would, but that doesn't mean it couldn't be done. Mostly it just seems impossible to design a carrier clip that could hold both well...more likely it would hold one well and the other poorly, or both poorly. Anyway, is there
Electronics Forum | Mon Aug 20 12:28:41 EDT 2007 | slthomas
Is there any way to generate a printable (ASCII text)component info file? We don't have LAN capability on this machine, nor do we use PPS, and I can not for the life of me figure out how to print something to help the operator set it up. Worst case i
Electronics Forum | Wed Aug 22 11:58:11 EDT 2007 | ev
Thanks for all responses really good feedback. I have placed a number of extra supports underneath each pcb in the panel and by checking each print diligently we seem to be able to keep running. Not feaseable at the moment to check out leaded paste o
Electronics Forum | Thu Aug 30 09:56:16 EDT 2007 | blnorman
According to J-STD-033 Table 4-1, the bake out time to restore the clock to zero is not only determined by the MSL level, but the package thickness as well. Section 4.2.2 states "SMD packages shipped in low temperature carriers may not be baked in t
Electronics Forum | Fri Aug 24 15:06:11 EDT 2007 | stepheniii
What kind of boards are they? Unless they are very simple boards, you won't be able to just replace every TH component with a SM equivalent. The inherent LCR characteristics of the board will change I think the normal way would be not to change the
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
