Electronics Forum | Tue May 11 02:22:18 EDT 2004 | Erhan
Snehal, For me to be able to help you, it depends on your location, type of application and volume. My email address is philipchip@yahoo.com if you wanna discuss further. Erhan
Electronics Forum | Mon Feb 13 13:46:23 EST 2006 | slthomas
You can put metal in a microwave (at least you can mine) as long as it doesn't contact the enclosure, but there's no way you'll get consistent heating of the volume in a microwave, even if it employs a "carousel".
Electronics Forum | Wed Jan 31 17:37:23 EST 2007 | GS
Hi, as for IPC-7095, in case of BGA, other important value to inspect/measure (3D) is the volume of paste deposit, mainly when mounting Ceramic BGAs. Regards...GS
Electronics Forum | Thu Dec 06 11:51:11 EST 2007 | lysik
We use a dual pot ERSA system. It is outstanding. Saved about 3000 hours of labor a month. Very expensive but worth it. We also looked at JUKI it was also a nice system. It was very flexible but the ERSA was better suited for high volume.
Electronics Forum | Tue Jul 08 10:41:14 EDT 2008 | aj
Hi all, I was carrying out some trials and the attached image is something that puzzled me . What would be the cause of this ? is it excess volume ? poor wetting? aj...
Electronics Forum | Fri Aug 01 00:22:46 EDT 2008 | fowlerchang
Pattern design, paste volume,printing misalignment, place misalignment,reflow process include N2 usage. All the factor above can make tombstome happen. And the most important factor is placement misalignment except design issue. But pls check the sol
Electronics Forum | Thu Apr 30 13:09:53 EDT 2009 | scottp
One factor I see missing is separation speed (or snap off speed). I've run experiments with different pastes where it was the biggest factor in standard deviation of print volume for small apertures.
Electronics Forum | Sat Apr 17 04:15:19 EDT 2010 | grahamcooper22
As a solder paste supplier I have profiled lots of different makes of ovens. I really like the Heller 1707. I have several customers who do lead free mid volume assembly with these ovens. They also seem to give shiny lead free joints.
Electronics Forum | Fri Apr 30 15:51:06 EDT 2010 | ldavis
We are using an Asscon VP800 with Galden LS230 fluid. This is a batch machine but is working well in our high mix-low volume environment.
Electronics Forum | Fri Mar 15 18:26:51 EDT 2013 | hegemon
We avoid kapton in this situation due to the thickness. 1 mil additional thickness can equal up to a 20% increase in paste volume at adjacent pads if you are using a 5 mil stencil. But then again, that is not always bad. But must be taken into consid