Electronics Forum | Wed Sep 02 16:11:29 EDT 2015 | emeto
My guess - GHOSTS!!! :) No seriously, you have to observe more about the timing and the sequence this thing happens. If it is absolutely random(which I doubt), than your machine might have serious problem. And when you say it is moving - is it movin
Electronics Forum | Thu Sep 03 09:02:38 EDT 2015 | derrikf
Yes. This is spot on. The machine is more than likely moving for a specific reason. You need to observe what it is doing while it is moving, when it's doing it, if it does it every time you perform a sequence of operations, or if it's occurs interm
Electronics Forum | Tue Sep 01 11:12:18 EDT 2015 | zombee
Problem is solved! There wasn't voltage on motor inputs (only 5-10V AC) when the motor connected correctly, but was ~210V AC without motor. Firstly, I exchanged the motor speed control relay (Panasonic G-series type), but the result was same. (the a
Electronics Forum | Mon Jan 18 02:49:03 EST 2016 | nirmex
1-Machine speed. 2-New Head H24 and DYNA Head. 3-New Feeder type W08f 4-New Part Camera. 5-New Y-Axis Flat cable design. 6-New GUI with Touch Screen. 7-Panel Height detection. 8-Feeder raising detection. 9-NPI tools support. 10-Overall machi
Electronics Forum | Tue Sep 15 11:34:20 EDT 2015 | emeto
Hi Dan, you got the basics, so follow your plan. With these machines the most critical part is the fluxer. Most of the m get clogged easily and should be maintained very good.So if there is any tubing, fitting or other type of connector that might b
Electronics Forum | Wed Sep 02 13:54:47 EDT 2015 | derrikf
I noticed a post from a few years ago with a guy looking for the same part, he was directed to Island SMT. Unfortunately, they do not currently have any in stock at the moment. This QA unit was used on Q-series machines made by Quad/Tyco, it was als
Electronics Forum | Fri Sep 04 21:04:33 EDT 2015 | sarason
How high a voltage are we talking , 240 volts, 4000 volts , 26000, volts 60,000 volts, 240 volts is easily done as we go up the scale insulation becomes a bigger problem and winding machines have to be much better in control of tension,also at higher
Electronics Forum | Mon Sep 21 07:47:31 EDT 2015 | koprivecj
Greetings! I have a problem with PAD connection in inner layers of 4 layer PCB (signal1, GND, POWER, signal2). Sometimes there is no connection between pad and power plane. I'm using termal relief around PAD in inner layers (same shape pad trough who
Electronics Forum | Tue Sep 22 08:03:49 EDT 2015 | mervin
Hi. I have recently purchased a old MPM UP2000. I can not get it print correctly consistently. It goes off after 5 Pcb's and remain that amount off for another 5 Pcb's. Then it goes more off and remain like that for another 5 Pcb's. If you stop and e
Electronics Forum | Tue Sep 29 10:10:34 EDT 2015 | swag
We used to have a UP3000. Long time ago so I'm rusty but isn't there a setting for fid correction that you an program to occur after each board or after 5, 10, etc.? I thought I remembered doing offsets on ours as the camera was a little wacky (old
