Electronics Forum | Fri Sep 09 06:03:37 EDT 2016 | jswatt
Simple answer is no you cannot do it and why would you?.. is it a cost saving thing? As Dave F correctly points out you have a fair amount of noxious fumes to handle that aren't getting exhausted if you switch of the extraction so they will go to you
Electronics Forum | Tue Jul 12 08:54:34 EDT 2016 | leeg
well there you go. I found that trying > different values in the "Placing Stroke" had a > big effect. I changed it to 2mm and it placed > them well, but I could see the board also flexing > a little, went to 1mm and the problem came back, > so
Electronics Forum | Fri Jul 15 05:27:59 EDT 2016 | salini
Thanks for the suggestions..will ask my RnD team to introduce such procedures which can replicate the points you have mentioned. We have initiated to implement the MSD devices proper handling in our factory premises so that field rejections which ar
Electronics Forum | Tue Jul 19 18:05:31 EDT 2016 | davef
I'm not real clear on what you're looking to understand, but let me get things started ... IPC-A-610F - Acceptability of Electronic Assemblies, 7.3.3 Supported Holes – Wire/Lead Protrusion Minimum length: You need to be able to discern the compone
Electronics Forum | Tue Jul 19 08:48:34 EDT 2016 | davef
Hi Pavel … Sad that you lost your "Soldering In Electronics" by R. J. Klein Wassink Points are: * According to Google Books, there is no eBook [https://books.google.com/books/about/Soldering_in_Electronics.html?id=P1aaAAAAIAAJ]. * Publisher: Elect
Electronics Forum | Thu Aug 25 03:09:32 EDT 2016 | buckcho
Hi,going to buy a new pick and place,any advise? > AM100 (Panasonic) vs e series (siplace). I think > both spec is quite similar. > > Thanks in > advance. It is very important to know what are you going to use them for. Selecting such machine
Electronics Forum | Tue Jul 19 18:08:28 EDT 2016 | dman97
Hello, I am having trouble getting our old CP3 to start up. When the machine starts to run, or when we try to center the nozzles, the CAM moves to 300 degrees and stops. The station 5 rotor just turns and turns with out ever centering the nozzles.
Electronics Forum | Thu Jul 21 14:54:32 EDT 2016 | ttheis
Acetone is flammable and hazardous to deal with. The fewer fire hazards and nasty fumes the better in my opinion. I would either go with a alcohol based no-clean for economical processesing and boards that can't be washed, or water washable if you ca
Electronics Forum | Thu Jul 21 23:06:51 EDT 2016 | adamjs
Water washable no-clean flux Hrm, I have not heard of paste that is both of these things (water-wash and no-clean-safe) at the same time, at least not as a solder paste vehicle. Does Kester make one? Can you recommend a particular product (prefer
Electronics Forum | Thu Jul 21 23:09:59 EDT 2016 | adamjs
flammable and hazardous to deal with Just want to point out that this is redundant, the only hazard is flammability. Acetone is about as non-toxic as it gets (as long is it isn't in your EYES) and probably *the* most safety-studied solvent in histo