Electronics Forum | Thu Sep 01 08:30:54 EDT 2016 | bukas
Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > www.dekhead.com > Certainly possible CPU board issue; but check PC > power supply, that all DCV are present and > strong. > > http:/
Electronics Forum | Thu Aug 25 17:24:44 EDT 2016 | davef
Gold should not be corroding in salt water. I have swum hundreds of miles in salt water with my wedding ring on my finger. My ring is a shiny and corrosion-free as the day it was cast over 120 years ago. It's possible that your gold thickness of 0.0
Electronics Forum | Thu Aug 25 08:22:41 EDT 2016 | bobpan
If I have to guess then I would say the machine is first picking up a larger nozzle to pick up this part.....the nozzle is not seating on the z-rod correctly and causing a problem. Check to make sure the nozzle is being mounted correctly. You may als
Electronics Forum | Thu Sep 08 15:22:32 EDT 2016 | bobpan
If its a tall part and you are trying to scan it lower than 200 or so...you can have this problem (limit error). Thinking of things to look at.....Is your z-rod spring sticking? Push up on it and it should spring back with NO hesitation...if it does.
Electronics Forum | Tue Aug 30 07:44:39 EDT 2016 | ariss_t
Very good explanation.. yep.. after 4 set of vision cable and a new usb3 port, the problem solve.. seems like the purple cable were the root cause .. The 1st cable on marginal pass failed but not shown the "camera 0" error and we still can poll the
Electronics Forum | Fri Aug 26 19:59:02 EDT 2016 | mhanrahan
We've just purchased a CP45FV Neo to replace an ancient Panasonic line. First non-Panasonic placement equipment I've worked on, so learning as I go here. So far it's been pretty straightforward. However, we use some parts that come in QFN or LCC p
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Thu Sep 01 12:07:35 EDT 2016 | pavel_murtishev
Is there any field proven spray cleaning technique able to remove flux residues under OSRAM LEDs? Is it possible in principle? The problem is that OSRAM LEDs are low standoff ones and I absolutely have no idea how cleaning agent could get there. Mo
Electronics Forum | Thu Sep 08 12:37:55 EDT 2016 | mmjm_1099
We stated placing labels on our lines for a couple years now and over the past year it has really taken off. Hover-Davis is the place you need to contact in order to get the correct feeder for your machines. They will want a single column label with