Electronics Forum | Fri Jun 27 11:56:37 EDT 2014 | sumote
Colleagues, I have a JT-620L Wavesolder machine (Made by JYI DIANN MACHINE) that experienced a power fluctuation and had the factory programming wiped. If someone would be so kind to read the settings on the (4) VS-606V7 controllers I would be very
Electronics Forum | Mon Jun 30 03:21:38 EDT 2014 | sramos
Thanks Alexei for your advice. I consider mainly high-volume production with tape/reel feeders for most components and tray for big ICs. My ultimate goal is a cost estimation of the production activities. So departing from a parts-list, I need to est
Electronics Forum | Wed Jul 02 02:08:16 EDT 2014 | alexeis
Hi, What types of failures are discovered at specified? Is it the problems of deviations, angles or incorrect component form? Our customers use software tool QPlan to prepare placement programs (SMT SETUP). It includes simulation, automatic correcti
Electronics Forum | Thu Jul 03 10:10:26 EDT 2014 | jorge_quijano
Hola We do AOI for most of our products, but a few ones goes to visual inspection only... -I have the inspection stations with a magnifier & some with a microscope. -I also use an "inspection mask" which has been very useful, it actually covers the P
Electronics Forum | Thu Jul 03 11:27:06 EDT 2014 | bobpan
Try these things: 1. Reseat the cards (with power off) and Reboot the machine and see if the errors clear. 2. Unplug the nozzle changers and try to reboot....sometimes they can mess up the system. 3. If all the above fails.....the b-rams in the card
Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Mon Jul 07 21:33:15 EDT 2014 | andrespena
The problem about covering it with glue (without using solder) is that the components might dislodge by a miniscule amount underneath the glue. So maybe the contact points will disconnect. I'm not sure if this will be a real problem, but if so it wo
Electronics Forum | Thu Jul 10 21:11:11 EDT 2014 | andrespena
@Alexei Shkolnik Ah, I hope this doesn't become a problem. But if it does perhaps we can redesign the whole system? Push the components with a pusher that's connected from above rather than pulled by a magnet below. Perhaps the pusher can still clim
Electronics Forum | Tue Jul 08 10:29:56 EDT 2014 | mleber
We are experiencing FOD coming off of a Cooper Bussman fuse. The components are dark with a metal like substance. In our testing based on what we were seeing we placed components onto a piece of FR4, placed a drop of flux onto the component and ran t
Electronics Forum | Thu Jul 10 17:25:57 EDT 2014 | jorge_quijano
I've seen both: Different operator using same tool = different splicing Same operator using different tool = Depends on the operator I remember some years ago I did an experiment with my 'splicers': their only job was to splice the tape, and then a