Electronics Forum | Sat Jul 24 04:02:21 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch
Electronics Forum | Mon Aug 02 13:06:10 EDT 2004 | jbabson1
If the CP7 is like the CP643, it defaults to the MAX size unless that nozzle is skipped. Then it would switch to the next smaller nozzle on that head.
Electronics Forum | Mon Feb 19 07:31:43 EST 2007 | jax
Check the nozzle. If these are the only two parts on the board that use a specific nozzle, it's a good place to start. The nozzle is probably not releasing well and shifting the component when trying to retract after placement...
Electronics Forum | Fri Jul 10 08:50:04 EDT 2015 | jax
Is the feeder working properly... presenting the label at the same location each time it indexes? If yes, I would look at changing nozzles on the machine. sometimes a rigid tipped nozzle cannot maintain suction on thin items like labels that can ben
Electronics Forum | Tue Jul 20 04:16:02 EDT 2004 | Charles Huang
Wondering if there any CP7/F4G programmers out there that can help me out with this one. I'm assuming the setting for max and min nozzle in the "environment" section of the part data would allow me to use either the specified max OR min nozzle in th
Electronics Forum | Wed Nov 29 01:20:44 EST 2006 | fastek
Guess- If a component drops at the camera the machine will not proceed to attempt to place it and drive the nozzle into a brick of solder paste. The line sensor will catch the fact there is no component on the nozzle and will retry to pick and place.
Electronics Forum | Tue Feb 20 23:46:38 EST 2007 | Muhammad Haris
hi Jax the nozzle which i am using for these components are also used for large SOPs and other components so i cant blame my nozzles.The problem is, they always shift to some 5 degree plus but some times it place them accurately.
Electronics Forum | Tue Jul 14 14:42:30 EDT 2009 | snsmt
The Tant size is 3528-21. I use type 72 nozzle for it.
Electronics Forum | Tue Dec 19 09:27:39 EST 2017 | cuervo
have anyone a pick and place made in china with conveyor and 4 or 6 nozzle
Electronics Forum | Mon Jul 13 13:48:37 EDT 2009 | christian01976
Hello! You can check your vacuum in MANUAL and then VACUUM IN MONITOR. You can switch the vacuum on or off for each head. With a TYPE 72 nozzle and no component the vacuum should be around 80 or 90 and with a component at the nozzle it should be ove
winsouce.jpg)