Electronics Forum | Mon Nov 26 14:27:49 EST 2007 | wayne123
I am using a search area of 2.5mm and I use a Red dot sticker to cover up board fids to not be built. I have it set to reflect. threshold is around 100 but that could be different depending on what you are using to cover up your fiducials with. I w
Electronics Forum | Wed Feb 04 06:26:20 EST 2009 | sachu_70
Hi Peter, The defect you observe during the second side reflow could be caused due to improper Au plating thickness in the PCB fabrication process. You can refer IPC-2221 wherein plating thicknes for ENIG mentions 0.08um to 0.23um for Immersion Gold,
Electronics Forum | Tue Apr 14 09:45:31 EDT 2009 | meritajs
Hello, Peter I suppose you could find Philips feeders here http://www.equipmatching.com/used_equipment/2/5/77099.php At this site you can put your ads about wanted equipment. We bought here many used Equipment for exelent price Best regards Peter
Electronics Forum | Fri Apr 10 13:25:08 EDT 2009 | jefflkupkt
Layer 2 is the ground plane layer of a 4 layer board. After installing a 2.5 mm DC power jack and 0.1 center SIP header by hand, the ground pin disconnects and causes an open. My board supplier said they passed Electrical Test. Prepreg was within
Electronics Forum | Fri Aug 07 13:29:53 EDT 2009 | cadone
Hi, We are designing a PCB where I need a Low height wire to board connector at the edge. I am looking for a 2 wire female surface mount connector that is not taller than 2.5mm Can any one here suggest me a place I can find this. Thanks CADone
Electronics Forum | Thu Apr 15 10:09:55 EDT 2010 | davef
Dross formation rates for SnCu and SAC are roughly 2.5 times the rate for SnPb (Hwang et al., 2004) Methods for reducing dross are: * Lower pot temperature * Run pump speed slower and only when soldering * Check solder contaminants to BS219, ASTM
Electronics Forum | Fri Nov 07 18:12:50 EST 2014 | cot628
This issue is coming from a customer. The customer demands that we do not mechanically center or test passive components, because of issues they had in the past. There has been a studies that it takes about 8-10 newtons to damage chip. Most of our pa
Electronics Forum | Thu Sep 17 10:18:54 EDT 2015 | huske
What model do you have? Are you working with a Midas only or Hydra as well? Are you looking for basic information on how to get started with chips and SO's? Or like how to use auto-teach or manually measuring parts and programming or more like select
Electronics Forum | Wed Mar 02 08:58:48 EST 2016 | mbass
From what I can rememeber I used to set x & y to zero advance the tap ethen it was press the lane and vaild button together to advance half a pitch which should bring it all into line. All the older RC software you could just put a manual adjustment
Electronics Forum | Mon Oct 31 09:28:31 EDT 2016 | douglashaines
Good morning. Could you please tell me where to acquire the manual and offline programming software for the following machine: MyData My9 TP9-2U? The original manufacturer isn't replying to my e-mails.
