Electronics Forum | Sat Aug 26 10:28:05 EDT 2006 | Ola
Hi, this is not a solution for your o-ring "belt" problem but a guideline for the future on an o-ring "belt" (wrong word as it is Not a belt) conveyor. These crazy O-rings have a small radius which makes it somtetimes hard to do a conveyor width adju
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Wed Aug 23 14:59:32 EDT 2006 | bill
I�ve been lurking on the forum for a while so I will take a stab at this, mainly because there is no answer I take it that you have a variety of boards being produced at the same time and are in fixtures so the conveyors don�t need to be adjusted, a
Electronics Forum | Thu Dec 20 14:04:35 EST 2001 | Dreamsniper
Hi Marc Definitely we will call you ! But as planned, we will be trying to move the fixed conveyor starting this morning and I think we need the two lead screws at both front and rear machined. We rang our local supplier here down under (australia) w
Electronics Forum | Wed Jan 27 17:32:51 EST 2016 | billthebuilder
We do High Mix, Low Volume and are looking for the best inline AXI with the criteria of industry-leading automation capabilities. The abilities to program offline, automatic conveyor width adjustment and board alignment are important to us. We want t
Electronics Forum | Mon Nov 11 11:42:26 EST 2002 | MikeF
Like Mark, I'm guessing your problem is with SMT parts on the top side, the solder is re-melting and some of the parts are moving around during when the board is being wave soldered. When I had some training on thru hole wave soldering way back when
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Wed Oct 20 07:59:34 EDT 2010 | gallionc
After 16 years in the industry, I have honestly never heard of putting wax in a solder pot. Anyway, I do have some experience with Treiber wave solder machines, and as I recall, the air-driven pumps are a nightmare to service. First of all, make su
Electronics Forum | Sun May 21 23:29:38 EDT 2017 | zsoden
Hi all, We run an old Seho 1135C wave solder with a 63/37 pot at 250°C. It has been running well for a couple of years but we have noticed lately that all of the larger pads (terminal blocks, transformers, etc.) require additional solder to be appli