Electronics Forum | Wed Jul 24 22:24:07 EDT 2013 | mac5
When we first got our XP1’s the cycle steal was on a schedule. We would have boards running good and then start placing off in the middle of a run. We finally noticed that the cycle steal had run just prior to the parts being misplaced. We have turne
Electronics Forum | Sat Aug 28 19:31:36 EDT 2004 | ryufoong
Currently, in my working factory, we facing the flux residue remain on connector after washing. (of course, this is clean process with WS solder paste). So, are there any ways to clean the flux residue rather than go back to wash again? Because wash
Electronics Forum | Mon Nov 22 09:31:29 EST 2004 | cyber_wolf
We have tried the vision both ways. Leads/body. Same issue. FYI Ken : The parts were not hitting the feeder pan on the back of the machine. I know this sounds really weird, but it seems that when we generate a program from Flexa(as opposed to FujiC
Electronics Forum | Thu Dec 08 22:41:44 EST 2005 | davef
Mike: You're correct, but in better shops there are guys with little black books in their back pocket. They know how to contol their variables and give you a good product. I worked at this plant where we cooked dirt. It glowed orange-red and flow
Electronics Forum | Thu Mar 30 13:15:31 EST 2006 | jdengler
This will depend on the feeder design. Some feeders cause a loss of several components when removing a reel from a feeder. If yours do not, the operator should be able to leave enough tape and mylar cover tape for this reel to be put back onto a fe
Electronics Forum | Sun Nov 22 18:03:38 EST 2015 | ttheis
Hi Deni- Thanks for the reply. I'll try to figure out what vision system is on it. I know it has two 5.3mil cameras front and back, UPS 3.2.2c os/2. Where do I determine the type of vision system; in the computer or harware spec plate?
Electronics Forum | Tue Nov 24 13:37:27 EST 2015 | ttheis
A shot of the screen is attached showing the version information. Where do I find the filters? It looks like the power goes from the switch to the large power distribution box which I presume has the back-up batteries inside. What method is recomme
Electronics Forum | Fri Feb 28 01:08:33 EST 2020 | sarason
Back in the 50's, 60's and 70's gold plated boards were all the rage for high reliability. test equipment, milspec etc. Nowadays only edge connectors are gold plated. Immersion plated gold is also used but it doesn't last the distance like gold plate
Electronics Forum | Thu Aug 31 14:27:23 EDT 2000 | Travis Slaughter
How to clean a contaminated board would depend on what it�s contaminated by, alcohol may be just the thing. If there is bare copper that has corroded that could be more of a problem, or maybe not if its due to poor tinning by the board house you coul
Electronics Forum | Thu Oct 25 04:52:17 EDT 2001 | Vai
I'm running intrusive reflow. What happened was when the board went thru' the first reflow ( which is secondary side ), at Post reflow, I can see the solder joint quality is very good smooth and shiny. But when we proceed with the 2nd reflow, at Post
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411